Table of Contents
Advertisement
Power-On Self Test (POST)
Table 5-11
POST Diagnostic Front Panel LEDs and Beep Codes (continued)
Activity
Red Power LED flashes ten
times, once every second,
followed by a 2-second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
System does not power on
and LEDs are not flashing.
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
5-20
Beeps
Possible Cause
10
Bad option card.
None
System unable to power on. Press and hold the power button
Chapter 5
Troubleshooting the System Hardware
Recommended Action
Check installed cards by
1.
removing the card (one at a
time if multiple cards), and
then power on the system to
see if fault goes away.
Once a bad card is
2.
identified, remove and
replace the bad card.
Contact Cisco TAC.
3.
for less than 4 seconds. If the
hard drive LED turns green, the
power button is working
correctly.
If the hard drive LED does not
turn on green then try the
following:
Check that the unit is
1.
plugged into a working AC
outlet.
Check that the power button
2.
harness is connected to the
system board.
Check that both power
3.
supply cables are properly
connected to the system
board.
Contact Cisco TAC.
4.
OL-17739-01
- Quick Links:
- Installation Guide
- Hardware Features
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
