Table of Contents
Advertisement
■ Method 3: Specifying the Sewing End
Point with an End Point Sticker
Memo
• (For users of XP1)
KIT II must be activated in order to use this
function. The optional Upgrade KIT II
(SAVRXPUGK2/UGKXP2/UGKXP2AP) is
required in order to activate KIT II.
For details on the procedure as well as
precautions, refer to the Operation Manual of
the optional Upgrade KIT II.
If KIT II is not activated, the key in step
not available.
• (For users of XP2)
For details on the procedure as well as
precautions, refer to "Specifying the Sewing
End Point" in the machine's Operation Manual
(Sewing).
a
With a chalk pencil, mark the fabric with
lines for sewing the stitch pattern and for
the end of stitching.
b
Affix an end point sticker, avoiding the
sewing area. Attach the end point sticker
within 4 cm (approx. 1-1/2 inches) to the
left or right of the chalkline where the end
point for sewing has been drawn.
a 4 cm (Approx. 1-1/2 inches)
Memo
• If you cannot affix an end point sticker
avoiding the sewing area, refer to "Temporary
Stop Setting" in the machine's Operation
Manual (Sewing) or the Upgrade KIT II
Operation Manual.
c
a
Refer to steps
through
Begin Changing the Angle at the End of
Sewing by Pressing the "Reverse Stitch"
Button" on page 6 to select the angle
settings for the start and end of sewing.
UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES
d
is
a
a
d
of "Method 1:
d
Touch
.
*
If the key appears in light gray, this function cannot
be used with the selected stitch length.
a
a Automatic reinforcement stitching function and
automatic thread cutting function are not
available.
e
Start sewing.
The machine stops automatically when sewing is
finished.
f
Peel off the end point sticker.
■ Saving Settings
Specified angle for start and end, finish tapering
method, and stitch settings can be saved in
machine's memory.
a
After setting the tapering function, touch
.
b
Touch
.
8
Advertisement
Table of Contents
