Table of Contents
Advertisement
SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Example: For a button with a diameter of 15 mm (9/16
inch) and a thickness of 10 mm (3/8 inch), the button
guide plate should be set to 25 mm (1 inch) on the
scale.
2
1 10 mm (3/8 inch)
2 15 mm (9/16 inch)
Pass the upper thread down through the
4
hole in the presser foot.
You need to sew the front bar tack first.
5
Lower the presser foot to align the marks
on the foot with the mark on the fabric.
1
2
1 Starting mark on the fabric
2 Marks on the foot
Lower the buttonhole lever and push it
6
back slightly.
1
1 Buttonhole lever
37
7
1
8
9
0
a
b
While gently holding the upper thread,
start the machine.
The bar tacks of the buttonhole are sewn
in the order shown.
3
2
4
1
Stop the machine when buttonhole
stitching is finished.
Note
● If buttonhole sewing was interrupted, sew
trial stitching one or two times on a scrap
piece of fabric before continuing to sew the
project. Stitching that is continued after
being interrupted may be sewn incorrectly.
● If thick seams are being sewn and the fabric
does not feed, sew with the coarser (longer)
stitch.
Raise the needle and the presser foot
lever, remove the fabric, and cut the
thread.
Raise the buttonhole lever to its original
position.
Insert a pin at the end of the buttonhole
stitching to prevent the stitching from
being cut, and then use a seam ripper to
cut towards the pin and open the
buttonhole.
2
1
1 Seam ripper
2 Pin
Advertisement
Table of Contents
