Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. SAFETY
WARNING! This tank must ONLY be used for diesel fuel and AdBlue®.
‰
Place the tank on a flat surface before filling.
9
Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the
9
warranty.
Keep the pump clean for best and safest performance.
9
Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).
9
Disconnect from battery when not in use.
9
Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available from
9
your local Sealey Stockist.
Keep children and unauthorised persons away from the working area.
9
DO NOT place the tank near any heat source.
8
DO NOT start or stop the pump by connecting or disconnecting the battery clamps.
8
DO NOT allow the unit to get wet.
8
DO NOT operate the pump with wet hands.
8
DO NOT use the pump where explosive or flammable vapours may be present.
8
DO NOT tamper with the pump connections.
8
2. INTRODUCTION
Manufactured from hard-wearing and durable polyethylene. Main 400L capacity tank suitable for diesel, supplied with a 12V, 40L/min pump kit
and automatic shut-off nozzle. A removable 50L tank for AdBlue®, supplied with a 12V, 17L/min pump kit and manual nozzle. Includes 2 x 4m
delivery hoses, 2 x dispenser nozzle holders, 2 x 4m of cable and clamps to connect to a battery. Covered by a lockable lid. Not suitable for
petrol. Complies to ADR 1.1.3.1.C for exemption from requirements of ADR regulations.
3. SPECIFICATION
MODEL NO: ............................................................... D440T
Capacity: ....................................... Diesel 400L/AdBlue® 50L
Current: ..................... Diesel Pump; 15A, AdBlue Pump®; 6A
Flow Rate: ....................... Diesel; 40L/min, AdBlue®; 17L/min
Power: .................................... Diesel; 180W, AdBlue®; 120W
Size (W x D x H): .................................. 1150 x 800 x 860mm
Voltage: ............................................................................12V
4. OPERATION
4.1.
TRANSPORT
4.1.1.
Move the empty tank assembly with two persons using the
hand holds moulded into the base of the unit (fig.1.1).
4.1.2.
Move with a forklift truck using the fork locations shown in
(fig.1.2). Ensure that the filler (fig.2.4) is closed before
moving.
4.1.3.
Secure the tank to the carrying vehicle by ratchet straps.
Locations for the straps are moulded into the tank. (fig.1.3).
4.2.
FILLING
DO NOT run the pump without fuel in the tank. To do so will
8
damage the pump's internal components and will void your
warranty.
4.2.1.
The tank is filled by unscrewing the filler (fig.2.4) in and
anticlockwise direction. Refit the filler cap immediately after filling.
WARNING! Take care not to overfill the tank.
‰
© Jack Sealey Limited
400L/50L PORTABLE COMBI FUEL TANK
MODEL NO:
Wear protective
Wear safety
gloves
footwear
Original Language Version
D440T
Wear protective
clothing
fig.1
D440T Issue 1 14/06/2021
Advertisement
Related Manuals for Sealey D440T
Summary of Contents for Sealey D440T
- Page 1 D440T MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 DO NOT use abrasive or solvent cleaners. ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. WEEE REGULATIONS Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk D440T Issue 1 14/06/2021 Original Language Version © Jack Sealey Limited...