Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
■ Attaching the extra spool pin
Insert the extra spool pin onto the end of the bobbin
winder shaft. Install the second thread spool onto
the extra spool pin.
■ Twin needle threading
You should thread each needle separately.
Note
● You cannot use the needle threader to
thread the twin needle. Instead, thread the
twin needle by hand, from front to back.
Using the needle threader may damage the
machine (see page 22).
Thread the upper thread for the right side
1
in the same way that the upper thread for
the left side was threaded.
1 Thread guide
• For details, refer to step
"Upper threading" (page 18).
Thread the left needle.
2
1 Bobbin winder shaft
2 Extra spool pin
3 Thread spool
1
1
0
through
Thread the right needle.
3
Thread the right needle in the same way that
you threaded the left needle using the thread
from the spool on the extra spool pin, but do not
pass the thread through the guide above the
needle before you pass it through the eye of the
right needle.
1 Left needle thread passes through the needle
bar thread guide
2 Right needle thread passes in front of the needle
bar thread guide
3 Needle bar thread guide
Attach zigzag foot "J".
4
For details on changing the presser foot, refer
to "Changing the presser foot" on page 8.
CAUTION
●
When using the twin needle, be sure to
attach zigzag foot "J", otherwise the
needle may break or the machine may be
damaged.
Turn on the machine.
5
CAUTION
●
Do not turn on the machine while pressing
down the foot controller. The machine
may start unexpectedly and cause
personal injury or damage to the machine.
Select a stitch.
6
of
CAUTION
●
After adjusting the stitch width, slowly
turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
●
When using the twin needle, make sure
the stitch width is not set above "2.5"
since this may cause the needle to hit the
needle plate and break.
3
2
1
2
28
Advertisement
Table of Contents
