Table of Contents
Advertisement
(Optional) Check the Software and Install a New Version
Procedure
Step 1
Connect to the CLI. See
procedure shows using the console port, but you can use SSH instead.
Log in with the admin user and the default password, Admin123.
You connect to the FXOS CLI. The first time you log in, you are prompted to change the password. This
password is also used for the threat defense login for SSH.
Note
Example:
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 2
At the FXOS CLI, show the running version.
scope ssa
show app-instance
Example:
Firepower# scope ssa
Firepower /ssa # show app-instance
Application Name
Version Cluster Oper State
-------------------- ---------- --------------- -------------------- ---------------
--------------- ------------------
ftd
Step 3
If you want to install a new version, perform these steps.
a) If you need to set a static IP address for the Management interface, see
Initial Configuration Using the CLI, on page
You will need to download the new image from a server accessible from the Management interface.
b) Perform the
Cisco Firepower 1100 Getting Started Guide
14
Access the Threat Defense and FXOS CLI, on page 38
If the password was already changed, and you do not know it, you must perform a factory reset to
reset the password to the default. See the
Slot ID
Admin State
1
Enabled
Not Applicable
reimage procedure
in the
Threat Defense Deployment with the Management Center
FXOS troubleshooting guide
Operational State
Online
19. By default, the Management interface uses DHCP.
FXOS troubleshooting
guide.
for more information. This
for the
factory reset
procedure.
Running Version Startup
7.2.0.65
7.2.0.65
Complete the Threat Defense
Advertisement
Chapters
Table of Contents
