PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 3. TROUBLESHOOTING GUIDE When receiving a rice boiler to be repaired, be sure to check that the main body is completely provide with the inner pan and the inner lid, ask the condition (phenmenon) of the trouble in detail. Before troubleshooting single parts, be sure to disconnect the power supply plug from the receptacle.
Page 6
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 Condition Troubleshooting Remedy Excessive burning. Does the center thermostat operate (More than light brown) Replace the center thermostat. properly? (Check with the evaporation test). Seeing at Table 2. Are the parts on the P.C.B. mistake? Improper operation...
Page 7
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 Table 2 Condition Troubleshooting Remedy Rice is not boiling. Replace the transformer. Is the transformer operating? (The indicating lamp does not come on) Replace the P.C.B. complete. Rice is not boiling. Replace the relay. Is the relay operation?
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 4. TESTING PROCEDURE 4.1 Bubbling test Input the pan in the main body, lightly rotate the pan clockwise and counter clockwise to settle the pan on the heating plate properly. 1. Fill water until center area of the pan bottom is dipped and close the lid. Then turn on the boiling switch.
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 The above conditions are proper. Top view of pan Pan flange Holes on the tissue paper Tissue paper 4.3 Heat reserving test 1. Put approx. 1 liter of water and the thermometer [ repairing tool (mercury thermometer ASN-150H) ] in the pan, close the lid and turn on the boiling switch.
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 4.5 Inner enclosure and upper frame removal 1. As show in the figure, pry up three fastening hooks. Fixing the upper frame, turn the inner enclosure in the arrow direction. 2. The upper frame will be seperated from the inner enclosure and the upper frame.
Page 11
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 4.6 Disassembly a control unit 1. Pull out the hinge shaft. 2. Pulling out wiring for lid heater and then pulling out outer lid ass’y. 3. Loosen a screw for bottom frame. 4. Loosen a screw for P.C.B. base 2 pcs.
Page 12
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 4.7 Disassembly cast heater and thermostat case ass’y 1. Loosen a screw for cast heater. 2. Bending leg of thermostat. Screw 3. Lift a thermostat. 4.8 Disassembly a side heater 1. Pulling out a side heater and after that if will replace new side heater, keep a distance between 23 ~ 27 mm.
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 5. PARTS EXPLODED VIEW AND REPLACEMENT PARTS LIST 5.1 Parts Exploded View : Body 13 of 19 2016/05/02 3:47 PM...
SR-TMG18 Important safety notice : Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturer’s specified part. 5.3 Replacement Parts List : SR-TMG18 Parts List COUNTRIES / Q’TY REF. PART NAME PART NO.
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 Screws COUNTRIES / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- INDO TAPPING SCREW XTB4+10GFJ FOR HANDLE SEMS SCREW XYN4+C10FNS FOR CAST HEATER ASSY SEMS SCREW XYN4+C7FNS FOR INTERNAL WIRING SPRING WASHER XWA4BPW FOR BODY EARTH LEAD WIRE...
PDF.js viewer file:///C:/Users/SH49A5~1.DEH/AppData/Local/Temp/Rar$EXa0.684/v... SR-TMG18 DETAIL CHANGE NOTICE REVISION ITEM NO. PAGE DETAIL REMARK JAN. 2010 CHANGE PART NO. OF PAN CHANGE COATING FROM 1 TO 2 LAYER AUG. 2011 ADD NEW PAGE FOR CONTENT IT’S PAGE NO. 2 2 - 18 NEW RUNNING PAGE NO.