Cisco NCS 540 Installation Manual page 46

Small density passive cooled routers

Hide thumbs Also See for NCS 540:

Table of Contents

Uninstall the Cisco USB Driver

Installation Wizard GUI is displayed.

3. Click Next. The InstallShield Wizard Completed window is displayed.

4. Click Finish.

5. Connect the USB cable to the PC and router USB console ports. Follow the on-screen instructions to

complete the installation of the driver.

6. The message displays that XR21V1401 USB UART Device driver is successfully installed.

The USB console is ready for use.

Uninstall the Cisco USB Driver

This procedure describes how to uninstall the Microsoft Windows USB device driver in Microsoft Windows

XP, Windows Vista, Windows 2000, Windows 7, and Windows 8.

Note

Disconnect the router console terminal before uninstalling the driver.

1. Choose Start > Control Panel > Add or Remove Programs.

2. Scroll to Windows Driver Package - Exar corporation (xrusbser) Ports and click Remove. The

Program Maintenance window is displayed.

3. Click Yes to uninstall the driver.

Connect to the EIA Console Port

Note

The USB-to-RJ45 adapter cable and the DB9 console cable are not included with the router; they can be

ordered separately from Cisco.

Note

The serial console cable kit is not included with the router; it has to be ordered separately.

To connect a terminal to the EIA Console port on the router, follow these steps:

1. Connect the USB end of the USB-to RJ-45 cable to the EIA Console port.

2. Connect the RJ-45 end of the DB-9 adapter cable to the USB-to RJ-45 cable, as shown in figure below.

Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide

Install the Cisco N540-6Z14S-SYS-D Routers

Table of Contents