Cisco NCS 540 Installation Manual page 26

Small density passive cooled routers

Hide thumbs Also See for NCS 540:

Table of Contents

Tools and Equipment

• #12-24 pan-head screws to secure the router to the equipment rack

• Cables for connecting to the network ports (depending on the configuration)

• Ethernet hub, switch, or PC with a network interface card for connecting to the Ethernet ports

• Console terminal (an ASCII terminal or a PC running terminal emulation software) that is configured

for 115200 baud, 8 data bits, no parity, no flow control, and 1stop bit

• Console cable for connecting to the console port

• Ratcheting torque screwdriver with a Phillips head that exerts up to 30-pound force per square inch (in-lb)

or 0.02-kilograms force per square millimeter (kgf/mm2) of pressure

• Crimping tool as specified by the ground lug manufacturer

• Wire-stripping tools for stripping both 6-AWG and 14-AWG wires

• Tape measure and level

Warning

Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49

Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide

Preparing for Installation

Table of Contents