Summary of Contents for HP BH9004E
- Page 1 BOATHOUSE BH9004E INSTRUCTIONS REIMANN & GEORGER CORPORATION MARINE PRODUCTS BUFFALO, NY 14225 P/N 6112172 06/01/01...
-
Page 2: Safety Precautions
13) A boat with water in it from a rain storm may exceed the weight capacity of the lift. Be certain to drain the boat before lifting it all the way up to its resting place. Make sure you replace the plug before launching your boat. -
Page 3: Installation And Setup
BOATHOUSE TO PREVENT PERSONAL INJURY AND/OR EQUIPMENT DAMAGE. LIFT ASSEMBLY Supporting beams must be installed to the spacing required by the boat to be lifted. The hangers will fit beams 6” wide by 6” to 9” deep. 1. Assemble #37X and #38X hangers and clamps to each corner of the boathouse beams about 6” wider than the beam of the boat. -
Page 4: Power Supply Connections
12. Pull the boat into the lift and raise it up slowly. If one corner tightens before the others, lower the boat. 13. Slide some wire rope through the loop in the spool from the loose corner toward the tight one to level the boat. If the blocks twist on themselves when unhooked, loosen the cable clamps at the block and unwind the wire rope until the block hangs straight. - Page 5 To reverse motor direction operation, reverse wiring of Black (T8) & Red (T5) at motor junction box. For motors greater than 3/4 hp, a higher rated switch must be used. Contact RGC for additional information. Remote Control - 110 VAC (3/4 HP Motors) Note: To reverse motor direction operation, reverse wiring of Black (T8) &...
- Page 6 5403261 5405001 15 FT. 5003189 5406966 BOATHOUSE – 9000 LB. PARTS LIST # 3103042 – BH9004E BOAT LIFT DESCRIPTION BH #37X HANGER BH #38X HANGER BLK HOOK SGL W / LATCH BLK HOOK DBL W/ LATCH BLK PLAIN DBL DESCRIPTION BH9004 CA 3/16 x 60’...
- Page 8 BH9004 Power Drive...