Cisco Firepower 1010 Hardware Installation Manual page 47
Hide thumbs
Also See for Firepower 1010:
- Getting started manual (190 pages) ,
- Getting started (42 pages) ,
- Deployment manual (8 pages)
Table of Contents
Advertisement
Installation, Maintenance, and Upgrade
Figure 36: Install Screws on the Bottom of the FIPS Cover
1
FIPS opacity shield
Step 5
Before you attach the TELs, clean the chassis and FIPS cover of any grease, dirt, or oil with alcohol-based cleaning
pads.
Step 6
Attach four of the TELs, three on the bottom of the chassis over the screws and one on the front of the chassis. See the
figure below for the correct placement. The figure shows the bottom of the chassis where you place three of the TELs.
Allow the TELs to cure for a minimum of 12 hours.
Any deviation in the placement of the TELs means the chassis is not in FIPS mode.
Caution
2
Three M3 x 66 mm Phillips screws
Cisco Firepower 1010 Hardware Installation Guide
Install the FIPS Opacity Shield
43
Advertisement
Table of Contents
