Transceivers, Connectors, And Cables; Transceiver And Cable Specifications; Rj-45 Connectors - Cisco 8800 Series Hardware Installation Manual

Hide thumbs Also See for 8800 Series:

Manual (544 pages)

Administration manual (406 pages)

User manual (218 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

page of 140

/ 140
Contents
Table of Contents
Bookmarks

Table of Contents

Connect Router to the Network

Note

In a dual Route Processor router, you can ensure that the active Route Processor card is always connected to

the network by connecting the management interface on both Route Processor cards to the network. That is,

you can perform this task for each Route Processor card. When the Route Processor card is active, the router

automatically has a management interface that is running and accessible from the network.

Caution

To prevent an IP address conflict, do not connect the MGMT 100/1000 Ethernet port until the initial

configuration is complete.

Before you begin

You must have completed the initial router configuration.

Procedure

Step 1

Connect a modular, RJ-45, UTP cable to the MGMT ETH port on the Route Processor card.

Step 2

Route the cable through the central slot in the cable management system.

Step 3

Connect the other end of the cable to a 100/1000 Ethernet port on a network device.

What to do next

You are ready to connect the interface ports on each of the line cards to the network.