Table of Contents
Advertisement
Attach the Router onto the Mounting Bracket
Step 1
Assemble six sets of bracket hardware (washer, split-lock washer, and bolt), as detailed in
on page
12.
Step 2
Place the mounting bracket (6) against the mounting plate by inserting the bracket quick-hang notch (2) over the mounting
plate quick-hang stud (5).
Step 3
Thread the serrated nut onto the quick-mount stud (4) and hand tighten (do not over tighten).
Step 4
Align the pivot grooves (7) on the bracket with four of the bracket-mount holes (1) on the mounting plate. Follow these
guidelines:
• Each of the four pivot grooves on the bracket must be attached to at least one bracket-mount hole on the mounting
plate.
• The final orientation of the mounting plate and router determine which bracket-mount holes are used.
• Mount the router, as described in
Step 5
Insert one bolt assembly (3) through one of the pivot grooves (7) on the bracket and then through the corresponding
bracket mount hole on the mounting plate.
Step 6
Repeat Step 5 for the remaining bolt assemblies.
Step 7
Position the mounting-bracket onto the mounting plate, as needed, before further tightening the bolts.
Step 8
Use a socket wrench to evenly tighten all four bolts and the serrated nut to finish installing the bracket on the plate. Use
a torque of 6 to 7 foot-pounds when tightening the bolts and nut.
Attach the Router onto the Mounting Bracket
This section describes how to attach the IR8140H to the mounting bracket.
Required materials:
• 13-mm box-end socket wrench
• Two sets of bracket hardware (split-lock washer, regular washer, and bolt). Attach each of the bracket
Step 1
Attach two sets of bracket hardware, one on either side of the IR8140H router.
Step 2
Slide the router onto the bracket and rest it on the two quick-hang slots (see
page
12).
Step 3
Use a socket wrench to evenly tighten the two sets of bracket hardware to secure the router to the mounting bracket.
Step 4
You are now ready to ground the router. See
Mounting the Router
14
Install the Mounting Plate On To a Pole, on page
sets to opposite sides of the IR8140H to provide support and enable it to rest on the bracket to each side
of the router (see
Figure 10: Assemble Bracket Hardware Set, on page
Grounding the Router, on page
Mounting the Router
Assemble Bracket Hardware,
6.
12).
Figure 11: Mounting Bracket Details, on
16.
Advertisement
Table of Contents
