Table of Contents
Advertisement
Install the Mounting Plate Mounting on Wood Pole (Optional)
Figure 8: Mounting Plate Installed on Pole with Steel Straps for a Pole Greater than 4.5 Inch In Diameter
Step 1
Assemble the straps and the mounting plate by threading the two steel straps through the band strap slots on the mounting
plate.
Step 2
Select a mounting location on the pole.
Step 3
Position the mounting plate on the pole, as needed, and tighten the straps around the pole.
Step 4
Use the BAND-IT strap tool to tighten the metal bands around the pole, following the instructions in the box that is
provided with the tool. Ensure that the metal bands are as tight as possible (approximately 7 ft lbs).
When the metal bands are tightened to the full tension, the mounting plate cannot be adjusted unless the metal
Note
bands are disassembled or cut.
Install the Mounting Plate Mounting on Wood Pole (Optional)
If the pole used in your installation is made of wood, you can optionally install the mounting plate using the
procedure described in this section. This is an alternate mounting method to the following two mounting
methods, which can also be used when mounting the router on a wood pole:
•
•
Required Materials
• Mounting plate as described in
• Hardware that you supply: 5/8-in. carriage bolt (length depends on the pole size in your installation),
• Tools that you supply: Drill, drill bit (for 5/8-in. through bolts), and 13-mm box-end socket wrench
Mounting the Router
10
Install the Mounting Plate—Poles Up To 4.5 Inches in Diameter, on page 7
Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter, on page 9
standard washer, fender washer, and nut (2 sets)
Pole Mount Kit, on page
2.
Mounting the Router
Advertisement
Table of Contents
