Lenovo ServeRAID M1210 Quick Installation Manual

Sas/sata controller for lenovo system x

Download this manual

Quick Installation Guide

ServeRAID M1210 SAS/SATA Controller for Lenovo System x

DANGER

Electrical current from power, telephone, and communication cables is hazardous.

To avoid a shock hazard:

• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this

product during an electrical storm.

• Connect all power cords to a properly wired and grounded electrical outlet.

• Connect to properly wired outlets any equipment that will be attached to this product.

• When possible, use one hand only to connect or disconnect signal cables.

• Never turn on any equipment when there is evidence of fire, water, or structural damage.

• Disconnect the attached power cords, telecommunications systems, networks, and modems before you

open the device covers, unless instructed otherwise in the installation and configuration procedures.

• Connect and disconnect cables as described in the following table when installing, moving, or opening

covers on this product or attached devices.

To Connect:

1. Turn everything OFF.

2. First, attach all cables to devices.

3. Attach signal cables to connectors.

4. Attach power cords to outlet.

5. Turn device ON.

Thank you for purchasing the ServeRAID M1210 SAS/SATA Controller

(hereafter referred to as controller) for Lenovo

install the controller, take a few minutes to read this quick installation

guide.

For more information about the controller, refer to the

ServeRAID M1210 SAS/SATA Controller for Lenovo System

x User's Guide on the ServeRAID matrix Web site at

https://support.lenovo.com/us/en/documents/serv-raid.

Technical support: To get assistance for installing, configuring, or

using the controller, go to http://www.lenovo.com/support.

To Disconnect:

1. Turn everything OFF.

2. First, remove power cords from outlet.

3. Remove signal cables from connectors.

4. Remove all cables from devices.

System x. Before you

Page 1 Quick Installation Guide ServeRAID M1210 SAS/SATA Controller for Lenovo System x Thank you for purchasing the ServeRAID M1210 SAS/SATA Controller ® (hereafter referred to as controller) for Lenovo System x. Before you install the controller, take a few minutes to read this quick installation guide.
Page 2 Then, grasp the controller by the top edge or upper corners, remove it from the package, and inspect it for damage. Contact your Lenovo sales representative or Lenovo reseller if the controller appears to be damaged.
Page 3 7. Install the server cover, connect the power cords, and turn on the server. Trademarks Lenovo, the Lenovo logo, and System x are trademarks of Lenovo in the United States, other countries, or both. Other company, product, or service names may be trademarks or service marks of others.
Page 4 First Edition (April 2016) © Copyright Lenovo 2016. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration “GSA” contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No.