Table of Contents
Advertisement
Installation
Placing the ONT on a Table or Shelf
Procedure
Step 1
Locate the adhesive strip with the rubber feet in the mounting-kit envelope.
Step 2
Attach the four rubber feet to the four circular etches on the bottom of the ONT.
Step 3
Place the ONT on a table or shelf near an AC power source.
Installing the ONT on a Wall
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware
or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
Statement 378
Caution
Do not wall-mount the switch with its front panel facing up. Following safety regulations, wall-mount the
ONT with its front panel facing down or to the side to prevent airflow restriction and to provide easier access
to the cables
Procedure
Step 1
Determine where you want to mount the ONT. Verify that the surface is smooth, flat, dry, and sturdy.
Step 2
Drill two pilot holes into the surface of the wall 153.20 mm apart.
Step 3
Insert a screw into each hole, leaving a gap between the surface and the base of the screw head.
Step 4
To attach a mounting bracket to the CGP-ONT-1P, perform the following steps:
a) Place the mounting bracket with the side containing the text This side is close to the chassis to the base
of the ONT.
b) Use the Phillips head screwdriver and attach the mounting bracket to the ONT using the mounting bracket
screws.
Cisco Catalyst PON Series Switches Hardware Installation Guide
Placing the ONT on a Table or Shelf
31
Advertisement
Table of Contents
Troubleshooting
