Table of Contents
Advertisement
Remove and Replace Field-Replaceable Units
•
•
Removing and Replacing a Fan Module
The fan module can be removed and replaced only on a CGP-OLT-8T.
Installation Guidelines
Observe these guidelines when removing or installing a fan module:
• Do not force the fan module into the slot. This can damage the pins on the device if they are not aligned
• A fan module that is only partially connected to the device can disrupt the system operation.
• The device supports hot swapping of the fan module. You can remove and replace the module without
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Removing the Fan Module
Before you begin
• See
• Ensure that you have the following tools and accessories available:
Removing and Replacing a Fan Module, on page 45
Removing and Replacing the Power Supply Module, on page 47
with the module.
interrupting normal device operation.
Installation
Guidelines.
• Phillips head screwdriver
• Antistatic mat
C H A P T E R
Cisco Catalyst PON Series Switches Hardware Installation Guide
3
45
Advertisement
Table of Contents
Troubleshooting
