Table of Contents
Advertisement
Installation
Attaching the Rack-Mounting Bracket and Mounting a OLT on a Rack
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Statement 1006
Before you begin
You should have the 19-inch rack-mounting bracket that is included with the shipping box.
Procedure
Step 1
Use the Phillips head screwdriver and attach the 19-inch rack-mounting bracket to an OLT using the
mounting-bracket screws. Follow the same steps to attach the second bracket to the other side.
Figure 12: Attaching Rack-Mounting Brackets on a CGP-OLT-8T
1
2
heaviest component at the bottom of the rack.
unit in the rack.
6xMounting-bracket screw
2xRack-mounting bracket
Attaching the Rack-Mounting Bracket and Mounting a OLT on a Rack
3
Front-mounting position
Cisco Catalyst PON Series Switches Hardware Installation Guide
23
Advertisement
Table of Contents
Troubleshooting
