Page 1
No. 0249 22LD3750DC «MODEL NAMES» 22LD3750DU SERVICE MANUAL MANUEL D'ENTRETIEN WARTUNGSHANDBUCH CAUTION: Before servicing this chassis, it is important that the service technician read the “Safety Precautions” and “Product Safety Notices” in this service manual. Data contained within this Service manual is subject to alteration for improvement.
1 INTRODUCTION The purpose of this document is to define the operation of 17MB29 chassis, capable of driving 22” TFT LCD panel. It is aimed to provide information to engineering staff to understand the operation and specs of the TV. The other related technical documents are given in Table1: Title 17MB29 schematics IR receiver and LED display board schematics...
Page 4
General default features • Multi System Reception: PAL-SECAM BG-DK-I/I’-L/L’ • Menu system (multi language) • 100 program storage locations • OSD (on-screen display) • Teletext • IR Control (RC5 and other customer specific protocols) • “No Ident” Timer • Child Lock •...
Page 5
Teletext/OSD • Simple Text 10 Pages • Fastext & Top Text (OPT) • Teletext Languages (ALL) • Character Based OSD Electrical features •IPS generates 12V and 5V DC supply. •<1W standby power consumption System Building Blocks 17MB29 chassis main blocks are as follows: •Analog Front End : VCTI (Microcontroller+Video Proccessor+Audio Proccessor+IF Demodulator+ Teletext Decoder+ OSD Generator) •Back End : MST-TSUMU38BF(Scaler, Deinterlacer, OSD Generator)
Back End MST-TSUMU38BF has two ADC inputs. First ADC input is assigned to the VCTI RGB output. Other RGB/YPbPr inputs are multiplexed for the second ADC input. HDMI receiver ANX9021 analog output, VGA RGB input and the synchronization signals are multiplexed by a primary RGB switch (PI5V512).
PORT SIGNAL NAME TYPE FUNCTION NAME HDMI_HP_INV HDMI hot plug signal Switching control for Mstar bus and system I2C Safety VCTI_HS VCTI composite sync output FBIN DVD_SENSE DVD module detection Vert+ TV/DVB_SW IDTV/TV I2C and AGC switch control for tuner Write protection control for NVM Infrared input Table 4.1 VCTI port configuration...
5.2 Infra-red & LED A five-pin connector is used between 17MB29 and the LED board: Pin2 and pin3 carry the control signals for the LED. Pin4 carries the infra-red signal to the microcontroller. Pin5 is used to power up the LED board.
Page 9
TDM1300 board has no tuner on it. Instead, the tuner of 17MB29 is used for both analogue and digital reception. Tuner is controlled by either the 17MB29 microcontroller (VCTI), or TDM1300 board microcontroller. The IF (intermediate frequency) output of the tuner is sent to TDM1300 board for digital reception.
5.4 DVD module board DVD module board has two parts: a loader and an electronic card. Electronic card controls the loader and has connections with 17MB29 and DVD keypad. Three cables are used to connect 17MB29 and DVD electronic card: power, data and sense. 12V (500mA) is sent to DVD electronic card by power cable: Y/C and/or CVBS video, stereo audio outputs and infra-red input of DVD module board is carried on data cable:...
5.5 LVDS connector MST-TSUMU38BF is used for dual LVDS output on 17MB29: Panel_Vcc1 is the power input for the panel LCD module. PIN7 signal is a logic 1 or 0 signal depending on the panel type. 5.6 IPS Power Card This product include AC-DC flyback converter, DC-DC converter and DC-AC half bridge converter.
6 IC SPECIFICATIONS 6.1 Microcontroller/Video&Audio Processor (VCT4913G) VCTI49xy is composed of microcontroller, video proccessor, display and deflection processor, sound proccessor and IF blocks as shown in figure below.
Page 14
VCTI49xyl family has two package types; PSSDIP88 and PMQFP144. PSSDIP88 package is chosen because of its convenience in the soldering process. PSSDIP88 package has two versions; 1 and 2. PSSDIP88-2 package is the “pinning mirrorred” version of PSSDIP88-1 and is preferred to be used for layout compatibility.
6.2 Scaler/De-interlacer (MST-TSUMU38BF) The TSUMU38BF is total solution graphics processing ICs for LCD displays with panel resolutions up to XGA and WXGA+ / SXGA+ respectively. They are configured with a high-speed integrated triple-ADC/PLL, a high quality display processing engine, and an integrated multi-purpose output display interface that can support all major panel interface formats.
Page 17
PORT SIGNAL TYPE FUNCTION NAME NAME PWM0 AN/DIG_DIM Analog or digital dimming control PWM1 BKL_ON/OFF Backlight On/Off Control PVCC_ON/OFF O Panel Logic Power On/Off control PWM2 PC/HDMI_SW Video switching control Table 6.2.1: MST5x7A-M port allocation...
6.3 Audio Stage Audio Preamplifier(LM358D) These circuits consist of two independent, high gain, internally frequency compensated which were designed specifically to operate from a single power supply over a wide range of voltages. The low power supply drain is independent of the magnitude of the power supply voltage. Audio Amplifier (MP7721) The MP7721 is a stereo 2 x 10W Class D Audio Amplifier.
6.4 Headphone Amplifier (TDA1308T) TDA1308T is an integrated class AB stereo headphone driver contained in an SO8, DIP8, or a TSSOP8 plastic package. SO8 package is used in 17MB29. The device is fabricated in a 1mm CMOS process. The main features of this IC are: •...
6.6 HDMI Receiver (ANX9021) The ANX9021 is an advanced multimedia receiver compliant with High Definition Multimedia Interface (HDMI) Specification 1.2. HDMI is the first transport standard to unify digital video, audio, and control da ta over lowcost cables. It connects digital television, flat panel displays and project systems digitally to multimedia sources: DVD players, high definition settop boxes, digital video tape recorders, and personal computers.Digital transmission, in turn, delivers an uncompromising multimedia experience.
• Low On-Resistance: 5Ω • Low crosstalk at 10 MHz: –90dB • Ultra-low quiescent power (0.1µA typical) • Single supply operation: +5.0V • Fast switching: 10ns Packaging (Pb-free & Green available): 24-pin 150-mil wide plastic QSOP (Q) • 6.8 Tuner (DTT71306) DTT713xx is a digital terrestrial tuner designed for reception in VHF I, VHF III and UHF, compliant with the European digital terrestrial standard ETS 300744 and CENELEC standards EN 55013 and EN 55020.
• General-purpose port output • Antenna power supply input 6.9 SAW Filter (X6966M) 6.10 I2C Switch (74HCT4053) 74HCT4053 is a triple 2-channel analog mux/demux with a common enable input. Each multiplexer/demultiplexer has two independent inputs/outputs (nY0 and nY1), a common input/output (nZ) and three digital select inputs (S1 to S3).
6.11 Audio DAC (CS4334) CS4334 is a 8-pin, 24-bit, 96KHz stereo D/A converter. The CS4334 family is based on Delta-Sigma modulation, where the modulator output controls the reference voltage input to an ultra-linear analog lowpass filter. This architecture allows for infinite adjustment of sample rate between 2 kHz and 100 kHz simply by changing the master clock frequency.
6.12 IC EEPROM 2Kbx8(24LC02) The 24LC01/02 is a 1K/2K-bit serial read/write non-volatile memory device using the CMOS floating gate process.Its 1024/2048 bits of memory are organized into 128/256 words and each word is 8 bits. The device is optimized for use in many industrial and commercial applications where low power and low voltage operation are essential.
Page 29
Description FRONT C OVER LCD22784 W/H LENS LED 2832 WRF LE NS IR 2100 5 H1: 6 H2: 5 17 LD 69 SCREW P C ZN YSB 3 x 6.5 SPEAKER 16 R 5 W 31x94 mm. ROHS SCREW P C ZN YFMB 3x9.5 17 TK 83S BUTTON STAND-BY 1709W BUT.FUN.1709W (KROM MET.KAPLAMA)