Related Manuals for Honeywell Ultrak CSC100 U Series
Summary of Contents for Honeywell Ultrak CSC100 U Series
- Page 1 All manuals and user guides at all-guides.com CSC100xU Series CSC110xU Series Covert Cameras USER MANUAL Rev. A CSMU000835 09/15/03...
- Page 2 LEWISVILLE, TX 75057 (800) 796-CCTV ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY BE REPRODUCED BY ANY MEANS WITHOUT WRITTEN PERMISSION FROM HONEYWELL VIDEO SYSTEMS. THE INFORMATION IN THIS PUBLICATION IS BELIEVED TO BE ACCURATE IN ALL RESPECTS. HOWEVER, HONEYWELL VIDEO SYSTEMS CANNOT ASSUME RESPONSIBILITY FOR ANY CONSEQUENCES RESULTING FROM THE USE THEREOF.
- Page 3 All manuals and user guides at all-guides.com WARNING • TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE CAUTION C A U T I O N RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
-
Page 4: Table Of Contents
COMPLYING WITH ALL FEDERAL STATE AND LOCAL LAWS AND STATUTES CONCERNING THE MONITORING AND RECORDING OF VIDEO AND AUDIO SIGNALS. HONEYWELL VIDEO SYSTEMS SHALL NOT BE HELD RESPONSIBLE FOR THE USE OF THIS PRODUCT IN VIOLATION OF CURRENT LAWS AND STATUTES. -
Page 5: Section 1: Introduction
All manuals and user guides at all-guides.com SECTION 1: INTRODUCTION PRODUCT DESCRIPTION The CSC Series covert cameras are designed to blend into commercial or office settings while providing superior resolution and low-light capability. Built-in voltage regulators prevent high voltage from reducing the life of the camera. -
Page 6: Section 2: Installation
All manuals and user guides at all-guides.com SECTION 2: INSTALLATION BEFORE INSTALLING Select a suitable location for the camera and enclosure. • Select a location where an intruder is most likely to cross the range of the detector. • Do not place the camera in front of windows subject to direct sunlight. - Page 7 All manuals and user guides at all-guides.com MOUNTING THE CAMERA, CONTINUED Connector Block Screw Terminal Figure 1: PCB Layout (CSC100BU/CSC100CU) Indicator Switches Connector Relay Screw Pyro Sensor Relay Grounding Jumper Figure 2: PCB Layout (CSC110BU/CSC110CU) Rev. A CSMU000835 09/15/03...
- Page 8 All manuals and user guides at all-guides.com MOUNTING THE CAMERA, CONTINUED 3. Use the provided knockouts to assist in mounting the unit. Use the side knockouts to mount the camera at an angle. Knock- outs Figure 3: Rear Housing Knockouts 4.
-
Page 9: Setting Dip Switches
All manuals and user guides at all-guides.com MOUNTING THE CAMERA, CONTINUED Setting dip 5. Several operation options and modes are selectable via switches DIP switches. (Models CSC110BU/CSC110CU only.) Option Description Pulse Counter Controls the amount of pulses (either 1 or 3 pulse mode) that need to be detected before the detector activates. -
Page 10: Walk Testing The Detector
All manuals and user guides at all-guides.com WALK TESTING THE DETECTOR A walk test is used to determine the lens coverage pattern of the detector and should be performed weekly. 1. Walk across the scope of the detector according to the detection pattern selected. -
Page 11: Section 3: Specifications
All manuals and user guides at all-guides.com SECTION 3: SPECIFICATIONS CSC100BU CSC110BU CSC100CU CSC110CU Image Sensor 1/3” Interline Transfer CCD CCD Lens 3.6mm pinhole lens 3.7mm pinhole lens Horizontal Freq. 15.750 KHz (EIA) 15.734KHz (NTSC) Vertical Freq. 60Hz (EIA) 60Hz (NTSC) Picture Elements 510(H) x 492(V) (EIA) 510(H) x 492(V) (NTSC) - Page 12 All manuals and user guides at all-guides.com Honeywell Video Systems South Africa 1305 Waters Ridge Drive 53 Juta Street Lewisville, TX 75057 Braamfontein 2001 +1-800-796-2288 South Africa www.ademcovideo.com + 27-11-403-3002 www.teqtrader.com United Kingdom Italy Aston Fields Rd. Via della Resistenza, 53/59 Whitehouse Ind.