Table of Contents
Advertisement
RUGGEDCOM WIN7225
Installation Guide
Section 1.2
Description
The RUGGEDCOM WIN7225 features various types of ports for connecting antennas and data adapters, and for
interfacing with the device.
Figure 1: RUGGEDCOM WIN7225
1. ANT 2 Port 2. RS-232 Serial Console Port 3. DC/ETH Port 4. GPS Port 5. ANT 1 Port
RS-232 Serial Console Port
ANT 1 and ANT 2 Ports
GPS Port
DC/ETH Port
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN7225:
Kits
• Class I, Division 2 Kit (P/N MKIT0090) – For hazardous
locations only
Tools
• Wrench or socket set
• Phillips screwdriver
• Drill with an 8 mm (5/16 in) drill bit
• Network cable tester
Description
1
2
3
An RJ45 serial console port for interfacing directly with the base station and accessing low-
level management functions. For more information about this port, refer to the RUGGEDCOM
WIN Base Station User Guide.
CAUTION!
Security hazard - risk of unauthorized access and/or exploitation. Restrict access
to the serial console port to authorized personnel only.
N-type female ports for connecting RF (Radio Frequency) antennas. Use only RG 214/U
coaxial cables.
A TNC female port for connecting the GPS antenna.
A Power-over-Ethernet (PoE) port for supplying power to the base station and connecting it
to the network.
Greases
• Marine grease (for marine applications only)
Tapes
• POE cold shrink (maximum 49.2 mm or 1.9 in inner
diameter before shrinking) or self-amalgamating tape
• UV-resistant vinyl tape
• Electrical insulation putty
4
5
Chapter 1
Introduction
3
Advertisement
Table of Contents
