Adjusting Height-Of-Cut; Maintenance - Toro ProLine 21” Recycler II Operator's Manual
Walk-behind power mower
Hide thumbs
Also See for ProLine 21” Recycler II:
- Operator's manual (60 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Available languages
Available languages
POTENTIAL HAZARD
Thrown objects may result if discharge
door does not close completely.
WHAT CAN HAPPEN
Thrown objects can cause serious
personal injury or death.
HOW TO AVOID THE HAZARD
If discharge door cannot be closed because
grass clippings clog discharge area, stop
engine and gently move discharge door
handle back and forth until door can be
closed completely. If door still cannot be
closed, remove obstruction with a stick, not
your hand.
5.
EMPTYING BAG—Stop engine and wait for all
moving parts to stop. Raise discharge door
handle and move it forward to engage the
locking pin with the catch (Fig. 14). Grasp
handles at front and rear of bag and lift bag off
mower. Gradually tip bag forward to empty
clippings.
6.
To reinstall bag, repeat steps 3-4.
Adjusting Height–of–cut
The height-of-cut is adjustable from approximately
/ to 3- / inches (19 mm to 83 mm), in / inch
(12.7 mm) increments (Fig. 10). Moving
height-of-cut adjuster forward raises height-of-cut.
POTENTIAL HAZARD
Adjusting height-of-cut levers could bring
hands into contact with moving blade.
WHAT CAN HAPPEN
Contact with blade could cause serious
personal injury.
HOW TO AVOID THE HAZARD
Stop engine and wait for all moving parts
to stop before changing height-of-cut.
Do not put fingers under housing to lift
mower when adjusting height-of-cut levers.
1.
Stop the engine and wait for all moving parts to
stop.
2.
For easier adjustment, lift housing up so wheel is
off ground. Do not place hands under deck to
lift housing. Squeeze adjusting lever toward
wheel (Fig. 16) and move it to the desired
setting. Assure pin on adjusting lever engages
notch in mower housing wear plate. Adjust all
wheels to the same setting.
Maintenance
NOTICE:
Maintenance, replacement or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However, to obtain no
charge repairs under the terms and
provisions of the Toro warranty
statement, any service or emission
control part repair or replacement
must be performed by an
Authorized Toro Service Dealer.
EN–10
Advertisement
Chapters
Table of Contents
