Checking The Hydraulic Lines And Hoses - Toro 03781 Operator's Manual
4-wheel drive traction unit
Hide thumbs
Also See for 03781:
- Operator's manual (64 pages) ,
- Service manual (468 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
1. Hydraulic filter
1. Hydraulic filter
4. Ensure that the filter mounting area is clean. Screw the
filter on until the gasket contacts the mounting plate;
then tighten the filter an additional 1/2 turn.
5. Start the engine and let it run for about two minutes to
purge air from the system. Stop the engine and check
for leaks.
Checking the Hydraulic Lines
and Hoses
Service Interval: Before each use or daily
Inspect the hydraulic lines and hoses daily for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
Figure 74
Figure 75
deterioration, and chemical deterioration. Make all necessary
repairs before operating.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Seek immediate medical attention if fluid is
injected into skin.
52
Advertisement
Table of Contents
