Table of Contents
Advertisement
Follow-Me Feature
• This feature lets users of each partition enter a phone number that the system will call in the event
of an alarm at the protected premises, thus alerting the user to the alarm.
• The message sent consists of a series of multi-frequency (DTMF) tones (beeps).
• If an alarm occurs, the system dials the follow-me phone number once, waits a short time after
dialing (about one ring), then begins the message tones (regardless of whether the call is answered).
If the call is answered before the second ring, the listener should be able to hear the message tones.
• In the event it takes longer than two rings to answer the call, it is possible the tones will have been
completed and the call disconnected. To help ensure that the tones are heard, you should set a
repeat count (1-7 repeats) that will cause the tones to be repeated that number of times, giving the
listener a better chance of hearing them. Note that only the tones are repeated during the single
follow-me phone call; the dialing is not repeated. The call is made only once.
• You can also program one or more 2-second pauses after the phone number, which will delay the
tones by that amount of time. This can help give the listener time to hear the tones. E.g., Adding
four pauses will delay the tones until after the phone rings twice.
To enter a follow-me phone number: user code + [#] + [6] [1]
The current follow-me phone number (if exists) for the user's partition is displayed:
FM Phone No.
18009216704--_
• Press [∗] to clear the existing number, then enter the desired phone number. The number is
automatically associated with the partition in which it is entered.
To include a 2-second dialing pause in the number, press [#] at the point in the entry the pause is
desired (it displays as "–").Pauses entered at the end of the number will allow dialing but will
delay the tones by the amount of pause programmed.
If no number is desired, leave the entry blank and go to the next step.
• Press [∗] to save the new number. The following prompt appears:
FM Repeat
1-7
• Enter the number of times, 1-7, the tones should be repeated during the follow-me phone call.
Setting/Adjusting the Real-Time Clock
The real-time clock is used to time-stamp events recorded in the event log and for scheduling mode.
The time display can be set for 12 (AM/PM) or 24-hour format, and can show day/month or
month/day (field *183, Time/Date Format). If the system is using the built-in crystal for the real-
time clock (field *181, 50/60Hz AC Operation) synchronization, a plus/minus adjustment may be
required to account for crystal frequency variation. This adjustment is only needed if the frequency
control of AC mains is not accurately maintained by the local mains electrical power provider.
To set and adjust the clock: user code +[#] + [6] [3].
The current setting is displayed.
Press [∗] to set the time. A cursor appears under the first digit of the hour.
• Enter the 2-digit hour setting, then enter the 2-digit minute setting.
• Press [1] for PM or [0] for AM (if applicable, otherwise skip).
• Enter the last two digits of the current year.
• Enter the 2-digit month setting, then enter the 2-digit day setting.
• Press [∗] to accept the settings and continue.
The Clock Adjustment prompt is displayed.
• Press [0] to add, or press [1] to subtract.
• Enter the number of seconds per day (01-59) to add or subtract to keep the real-time clock accurate.
• Press [∗] to accept the setting and exit.
1
6-7
Hide quick links:
Advertisement
Table of Contents
