TABLE OF CONTENTS ABOUT THIS GUIDE------------------------------------------------------------------------1 NATIONAL CONVENTIONS---------------------------------------------------------------1 FCC NOTICE --------------------------------------------------------------------------------- 2 PRECAUTIONS ------------------------------------------------------------------------------- 3 SETUP THE STAND AND BASE ------------------------------------------------------- 4 ADJUSTING VIEWING ANGLE ---------------------------------------------------------- 4 ATTACHING THE CABLES --------------------------------------------------------------- 5 WALL MOUNTING -------------------------------------------------------------------------- 6 EXTERNAL CONTROLS ------------------------------------------------------------------ 7 OSD SETTINGS ---------------------------------------------------------------------------- 8 IMAGE ADJUSTMENT ------------------------------------------------------------------ LED INDICATORS ------------------------------------------------------------------------...
About This Guide This guide describes the monitor’s features, setup, and operation. lnformation in this document is subject to change without notice. The sections are as follows: • Safety Instructions: lists safety information. • Setup: describes the initial setup process. •...
FCC Notice FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Precautions WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards Read and follow these precautions when connecting and using your computer monitor: PRECAUTIONS • Do not use the monitor near water, e.g.
Setup the stand and base Please setup or remove the base following below steps. Adjusting Viewing Angle • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference. •...
Attaching the Cables Cable Connections On Back of Monitor and Computer 1. Power Cord 2. DVI Cable 3. Analog Cable Turn off your computer before performing the procedure below. 1. Connect the power cable to the AC port on the back of the monitor. 2.
Wall Mounting Preparing to Install An Optional Wall Mounting Arm This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this procedure. Follow these steps: 1. Remove the base. 2. Follow the manufacturer’s instructions to assemble the wall mounting arm. 3.
External Controls Press the power button to turn the monitor on or off. The other control knobs are located at front panel of the monitor (See Figure ). By changing these settings, the picture can be adjusted to your personal preferences. * The power cord should be connected.
OSD Settings • Press the MENU-button to activate the OSD window. • Press + or - to navigate through the functions. Once the desired function is highlighted, press the MENU-button to activate it. If the function selected has a sub-menu, press + or - again to navigate through the sub-menu functions. Once the desired function is highlighted, press MENU-button to activate it.
Image Adjustment Luminance Adjust Range Description Contrast Contrast from Digital-register 0-100 Brightness Backlight Adjustment 0-100 Standard Standard Mode Text Text Mode Internet Internet Mode Game Game Mode Movie Movie Mode Sports Sports Mode On/Off Dynamic contrast ratio Image Setup Clock 0-100 Adjust picture Clock to reduce Vertical-Line noise Phase...
Problems and Solutions Problem and Questions Possible Solutions • Make sure the power button is ON and the Power Cord Power LED is Not ON is properly connected to a grounded power outlet and to the monitor • In order for the Plug & Play feature of the monitor to work, you need a Plug &...
Specifications Model Number Driving system TFT Color LCD Viewable Image Size mm diagonal Pixel Pitch mm (H) x 0. mm (V) LCD Panel R, G, B Analog Interface & Digital Interface Video Separate Sync. H/V TTL Display Color 16.7M Colors Dot Clock Horizontal scan range 30 kHz - 83 kHz...
EPA ENERGY STAR ® ENERGY STAR® is a U.S registered mark. As an ENERGY STAR® Partner, our company has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. Preset Display Modes HORIZONTAL VERTICAL RESOLUTION FREQUENCY (kHZ) FREQUENCY (HZ) 640 x 480 @60Hz 31.469 59.94...
DVI-D pins Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name TMDS Data 2- TMDS Data 1- TMDS Data 0- TMDS Data TMDS Data 2+ TMDS Data 1+ TMDS Data 2/4 TMDS Data 1/3 TMDS Data Shield Shield 0/5 Shield TMDS Data 4-...