Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
When embroidering with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
a
a Spool cap (small)
b Spool (cross-wound thread)
c Space
When using thread that winds off quickly,
such as transparent nylon thread or metallic
thread, place the spool net over the spool
before placing the spool of thread onto the
spool pin. If the spool net is too long, fold it
to fit the size of the spool.
When the spool net is used, the upper thread
tension may become tighter. Before
embroidering, refer to "Adjusting the upper
thread tension" (page 63).
a
c
a Spool net
b Spool
c Spool cap
d Spool pin
g
Pull the thread from the spool and pass the
thread under the hook of thread guide.
a Thread guide
b
c
b
d
a
h
Pass the thread behind the thread guide cover
and to the front.
While holding the thread near the spool with
your right hand, pull the thread with your left
hand as shown below.
a Thread guide cover
i
Pull the thread to the right, pass it under the
hook of the bobbin-winding thread guide, and
then wind the thread counterclockwise under
the pretension disc, pulling it in as far as
possible.
a Bobbin-winding thread guide
Make sure that the thread passes under the
pretension disk.
b
c
b Hook
c Pretension disk
d Pull it in as far as possible.
Winding/Installing the Bobbin 31
a
a
d
1
Advertisement
Table of Contents
