2. Be careful in handling ICs. Some ICs such as MOS type are so fragile that they can be damaged by electrostatic induction. CD-UB100/XN/UC...
Page 3
To protect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. CD-UB100/XN/UC...
• Screw adjacent to mark on the product are used for disassembly. • For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions,apply as you think it appropriate.) 2.1 PACKING CD-UB100/XN/UC...
Page 7
Fastener CNM6888 Fastener CNM6889 11-3 Warranty Card(UC) CRY1246 Air Cushioned Bag CEG1007 Warranty Card(E5) CRY1157 Carton(UC) CHG6068 Owner's Manual Part No. Language CRD4151 English, French, Spanish CRD4149 English, Spanish, German, French, Italian CRD4150 Dutch, Russian, Portuguese(B), Traditional Chinese, Arabic CD-UB100/XN/UC...
3.2 OVERALL CONNECTION DIAGRAM(GUIDE PAGE) Note: When ordering service parts, be sure to refer to " EXPLODED VIEWS AND PARTS LIST" or "ELECTRICAL PARTS LIST". Large size SCH diagram Guide page Detailed page C952 R001 C953 470P L610 R632 CD-UB100/XN/UC...
Page 13
Symbol indicates a resistor. Decimal points for resistor No differentiation is made between chip resistors and and capacitor fixed values discrete resistors. are expressed as : Symbol indicates a capacitor. No differentiation is made between chip capacitors and 0.022 R022 discrete capacitors. CD-UB100/XN/UC...
Capacitor Connector several destination. For further information for SIDE A respective destinations, be sure to check with the schematic dia- gram. SIDE B P.C.Board Chip Part MOTHER UNIT IP-BUS OUT IP-BUS IN RESET FRONT CD-UB100/XN/UC...
Page 19
SIDE A POWER SUPPLY FRONT CD-UB100/XN/UC...
R 204 (B,44,30) RS1/16S473J D 801 (A,122,79) Diode MPG06G-6415G50 R 205 (B,48,30) RS1/16S473J R 206 (A,42,30) RS1/16S473J D 811 (A,102,61) Diode HZS9L(B3) R 251 (A,31,53) RS1/16S103J D 812 (A,23,42) Diode DAN202U R 252 (A,40,53) RS1/16S103J D 821 (A,115,50) Diode HZS6L(B1) CD-UB100/XN/UC...
Page 23
R 509 (B,8,46) RS1/16S473J R 510 (B,9,34) RS1/16S473J R 663 (A,97,12) RS1/16SS0R0J R 511 (B,13,30) RS1/16S473J R 664 (A,100,10) RS1/16SS101J R 512 (A,20,10) RS1/16S102J R 665 (A,101,10) RS1/16SS101J R 513 (A,21,7) RS1/16S183J R 666 (A,103,10) RS1/16SS101J R 667 (A,104,10) RS1/16SS101J CD-UB100/XN/UC...
Page 24
C 602 (A,68,42) CEJQ100M16 C 908 (B,54,35) CKSQYB106K6R3 C 603 (B,74,41) CKSRYB104K16 C 952 (B,132,8) CCSRCH102J50 C 604 (A,74,42) CEJQ100M16 C 953 (B,121,23) CCSRCH471J50 C 605 (A,48,38) CKSYB475K10 C 606 (A,50,36) CKSRYB104K16 C 607 (A,49,34) CKSRYB122K50 C 608 (A,49,32) CKSRYB331K50 CD-UB100/XN/UC...
Confirmation on connection mode is D e v i c e I n getting ready. C o n n e c t Now connecting M S C Indication of connection mode When a device supporting mass storage class is connected CD-UB100/XN/UC...
7.1 DIAGNOSIS 7.1.1 DISASSEMBLY - Removing the Case (Fig.1) Case Remove the four screws and then remove the Case. Fig.1 - Removing the Mother Unit (Fig.2) Straighten the tabs at three locations indicated. Remove the Mother Unit. Mother Unit Fig.2 CD-UB100/XN/UC...
7.1.2 CONNECTOR FUNCTION DESCRIPTION POWER SUPPLY IP-BUS IN(BLUE) IP-BUS OUT(BLACK) BUS + BUS + BUSG1 BUSG5 B. UP BUSG1 BUSG5 BUS - BUS - BUSG1 BUSG5 BUSL1 BUSL3 ASENB ASENB BUSR1 BUSR3 BUSR2 BUSAG1 BUSL2 BUSAG1 USB5V CD-UB100/XN/UC...
Page 28
63-66 For consumption current reduction output DALMON Not used 68-70 ROM correction chip select output ROMCS asensb ASENBO sense bsens Back up sense input ROM correction : Clock output ROMCK ROM correction : Data input/output ROMDATA Not used 76-78 CD-UB100/XN/UC...
Page 30
Mode setting input 1. Pull-down for normal operation. MODE1 USB host port 0 D- signal USBH0_DN USB host port 0 D+ signal USBH0_DP Digital ground USB host port 1 D- signal USBH1_DN USBH1_DP USB host port 1 D+ signal Power for USB I/O (3.3 V) VDDUSB CD-UB100/XN/UC...
Page 31
GPIO_A[11] / I2C clock / GPSB/GSIO3 data in GPIO_A[11] Digital ground Digital power for I/O (3.3 V) VDDIO 120-123 EXINT[0]-[3] External interrupt request [0]-[3] Digital power for internal core (1.8 V) VDDI External bus data bit [0]-[3]. Internal pull-up resistor enabled at reset. 125-128 XD[0]-[3] TCC8600-00X-EA-AG CD-UB100/XN/UC...
*1 Besides this, USBPW(Pin 38) and Pin 67 USBCTL(Pin 47) are also set to H. Source switching : Other than to OFF Source switching : *2 The source can be switched USB *2 on without connected devices. SYSPW Pin 49 Pin 43 CD-UB100/XN/UC...