Table of Contents
Advertisement
Inserting the Power Supply Module in an OLT
Figure 20: Removing the Power Supply Module from CGP-OLT-16T
Caution
What to do next
Set the removed power supply module aside and proceed with either one of the following actions:
• Install the replacement or spare power supply module.
• Install the blank cover.
Inserting the Power Supply Module in an OLT
To insert the power supply module into the OLT, follow these steps:
Before you begin
• If you are installing a spare power supply module, see
• If you are installing a replacement power supply module, see
• Verify that the power supply is not connected to any power sources.
Procedure
Step 1
Hold the handle on the power supply module with one hand and position the power supply with its back end
at the open power supply bay.
Step 2
Slide the unit all the way into the power supply bay until the power supply module is firmly in place.
Cisco Catalyst PON Series Switches Hardware Installation Guide
46
If you intend to operate the Cisco Catalyst PON Series OLT without installing another power supply
in the empty slot, you must reinstall the blank cover over the empty power supply slot to ensure
proper airflow in the system and for safety reasons.
an
OLT.
Removing and Replacing Field-Replaceable Units (FRUs)
Removing a Power Supply Blank
Removing a Power Supply Module from
Cover.
Advertisement
Table of Contents
Troubleshooting
