Installing The Heat Sink Assembly; Power Connector Port; Removing The Power Connector Port - Dell Precision 3520 Owner's Manual
Hide thumbs
Also See for Precision 3520:
- Service manual (124 pages) ,
- Owner's manual (84 pages) ,
- Setup and specifications (24 pages)
Table of Contents
Advertisement
Installing the heat sink assembly
1. Place the heat sink assembly on the system board and align the heat sink with the screw holders.
2. Tighten the M2x3 screws to secure the heat sink assembly to the system board.
3. Connect the heat sink assembly to the connector on the system board.
4. Install the:
a.
battery
b.
base cover
5. Follow the procedure in
Power connector port
Removing the power connector port
1. Follow the procedure in
2. Remove the:
a.
base cover
b.
battery
3. To remove the power connector port:
a. Disconnect the power connector port cable from the connector on the system board [1].
b. Remove the M2x3 screw to release the metal bracket that secures the power connector port [2].
c. Remove the metal bracket that secures the power connector port [3].
d. Lift the power connector port away from the [4].
26
Disassembly and reassembly
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
