Maintain Transceivers And Optical Cables; Create The Initial Router Configuration - Cisco 8800 Series Hardware Installation Manual
Hide thumbs
Also See for 8800 Series:
- Manual (544 pages) ,
- Administration manual (406 pages) ,
- User manual (218 pages)
Table of Contents
Advertisement
Maintain Transceivers and Optical Cables
Maintain Transceivers and Optical Cables
Refer to
processes for fiber optic connections.
Create the Initial Router Configuration
You must assign an IP address to the router management interface to connect the router to the network.
When you initially power up the router, it boots up and asks a series of configuration-related questions. You
can use the default choices for each configuration except for the IP address, which you must provide.
When the system is powered on and the console port is connected to the terminal, the RP CPU messages are
seen. You can toggle between BMC CPU messages and RP CPU messages by pressing the hot-key sequence
Ctrl-O.
To configure IP address for Ethernet port on BMC and other additional information related to BMC, please
see the System Setup Guide for Cisco 8000 Series Routers.
Before you begin
• A console device must be connected with the router.
• The router must be connected to a power source.
• Determine the IP address and netmask that is needed for the Management interfaces:
Procedure
Step 1
Power up the router.
The LEDs on each power supply light up (green) when the power supply units are sending power to the router,
and the software asks you to specify a password to use with the router.
Step 2
When the system is booted up for the first time, a new username and a password is to be created. The following
prompt appears:
!!!!!!!!!!!!!!!!!!!! NO root-system username is configured. Need to configure root-system
username. !!!!!!!!!!!!!!!!!!!!
--- Administrative User Dialog ---
Enter root-system username:
% Entry must not be null.
Enter root-system username: cisco
Enter secret:
Use the 'configure' command to modify this configuration.
User Access Verification
Hardware Installation Guide for Cisco 8800 Series Routers
76
Inspection and Cleaning Procedures for Fiber-Optic Connections
and
:
MgmtEth0/RP1/CPU0/0
Connect Router to the Network
document for inspection and cleaning
MgmtEth0/RP0/CPU0/0
- Quick Links:
- Unpack the Chassis
Hide quick links:
Advertisement
Table of Contents
