Install And Remove Qsfp Transceiver Modules - Cisco 8800 Series Hardware Installation Manual
Hide thumbs
Also See for 8800 Series:
- Manual (544 pages) ,
- Administration manual (406 pages) ,
- User manual (218 pages)
Table of Contents
Advertisement
Install and Remove QSFP Transceiver Modules
Caution
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
(FTP) cable that is properly grounded at both ends.
The following figure shows the RJ-45 connector.
Figure 59: RJ-45 Connector
1
Install and Remove QSFP Transceiver Modules
This section provides the installation, cabling, and removal instructions for the Quad Small Form-Factor
Pluggable transceiver modules. Refer to the
on optical transceivers.
The following figure shows a 400-Gigabit QSFP-DD optical transceiver.
Figure 60: 400-Gigabit QSFP-DD Transceiver Module
1
3
Hardware Installation Guide for Cisco 8800 Series Routers
70
Pin 1
Pull-tab
Electrical connection to
the module circuitry
2
Pin 8
Cisco Optical Transceiver Handling Guide
2
Connect Router to the Network
for additional details
QSFP-DD transceiver
body
- Quick Links:
- Unpack the Chassis
Hide quick links:
Advertisement
Table of Contents
