Table of Contents
Advertisement
8.3.
How to Clear User Setting
Units are reset to the Factory settings by this operation (Erase recorded Voice messages, stored Phone numbers, Caller list and
etc.)
Note:
• Some menus are not reset. Refer to Operating Instructions (P.20).
• The reset menus differ depending on the following operations.
• This operation should not be performed for a usual repair.
8.3.1.
Resetting both base unit and handset
Both the base unit and the registered handset which you did the following steps
will not be reset.
1
Connect the AC adaptor to the base unit and install the charged batteries into the handset.
2
Confirm the handset is registered to the base unit (
If the handset is not registered to the base unit (
3
Lift the handset and press {ih} to put the handset in standby mode.
4
1
5
9
Press
,
,
5
Disconnect the AC adaptor, then remove the battery.
Note:
(*1) Refer to Registering a Handset to the Base Unit (P.38).
8.3.2.
Resetting only handset
The only handset is reset by doing the following steps
1
Install the charged batteries into the handset.
2
Lift the handset and press {ih} to put the handset in standby mode.
3
Press
3
,
5
,
7
4
Remove the battery.
Note: (*2)
• The handset registration to the base unit is cancelled.
• If the handset needs to be registered to the base unit, refer to Registering a Handset to the Base Unit (P.38).
• If users do not bring the base unit with them, the registration procedure has to be done by users themselves.
w
Handset
and
key of the handset simultaneously until a confirmation tone is heard.
and
#
key of the handset simultaneously until a confirmation tone is heard. (*2)
Base unit
lights).
lights), register it. (*1)
1
to
.
④
Handset
27
KX-TG6551CAM/KX-TGA650RUM/KX-TGA651RUM
1
to
are reset. Other registered handsets
④
Advertisement
Table of Contents
Troubleshooting
