Related Manuals for Sony SPM-TRI/C
Summary of Contents for Sony SPM-TRI/C
- Page 1 ® INSTALLATION MANUAL Sony Electronics Inc. 16450 West Bernardo Drive San Diego, CA 92127 www.sony.com/plasma...
- Page 2 At least two qualified people should always perform the installation work. Injury and damage can result from dropping or mishandling the plasma display. - 2 - Contact Sony for any questions Warning and caution in general...
- Page 3 Stand diagrams PART#: SPMTRI/C MATERIALS USED: 12 (GA) CRS, Clear acrylic base COLOR: Silver A. Back plate B. Stand support C. Clear base D. Security access screws E. (1) Cable access hole F. Fixed tabletop mounting holes 20.50 (520.7) 20.00 (508) 1.00 (25.4)
- Page 4 Step 2 The stand fits a 32" 42" and 50" PFM series (Sony plasma displays only). The plate is stamped with two plasma sizes. Check the size that fits your plasma before installing. NOTE: If using a 32” plasma, the plate is not needed. Mount the plasma quick release sleeves from the plasma to the key-holes on the uprights.
- Page 5 Securing the plasma to the stand Step 3 Raise the display with the securing sleeves installed to the plasma. Slip the sleeves through the four (4) keyholes on the back plate and drop it down slowly, make sure all of the four (4) sleeves are in the keyhole slot before letting go of the plasma. On the 42" and 50" two (2) M5 x 12 Phillip screws (security screws) can be used for additional security.
- Page 6 (Optional) fixed installation Step 1 Invert the stand and locate the two (2) mounting points on the bottom of the stand for (optional) fixed tabletop installation. Measure the distance between center to center of these two (2) holes and mark the table. See figure 4. NOTE: This diagram shows the bottom of the stand.