Configuring Online Diagnostics; Scheduling Online Diagnostics - Cisco Catalyst 9200 Configuration Manual
Hide thumbs
Also See for Catalyst 9200:
- Hardware installation manual (128 pages) ,
- Installing manual (8 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Configuring Online Diagnostics
Command or Action
Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic monitoring.
Scheduling Online Diagnostics
You can schedule online diagnostics to run at a designated time of day or on a daily, weekly, or monthly basis
for a Device. Use the no form of this command to remove the scheduling.
SUMMARY STEPS
1. configure terminal
2. diagnostic schedule number test {name | test-id | test-id-range | all | basic | complete | minimal |
non-disruptive | per-port} {daily | on mm dd yyyy hh:mm | port inter-port-number port-number-list |
weekly day-of-week hh:mm}
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Device# configure terminal
Step 2
diagnostic schedule number test {name | test-id |
test-id-range | all | basic | complete | minimal |
non-disruptive | per-port} {daily | on mm dd yyyy hh:mm
| port inter-port-number port-number-list | weekly
day-of-week hh:mm}
Example:
Device(config)# diagnostic schedule 3 test 1-5 on
July 3 2013 23:10
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
136
Purpose
• all—Starts all of the tests.
• basic— Starts the basic test suite.
• complete—Starts the complete test suite.
• minimal—Starts the minimal bootup test suite.
• non-disruptive—Starts the non-disruptive test suite.
• per-port—Starts the per-port test suite.
Purpose
Enters the global configuration mode.
Schedules on-demand diagnostic tests for a specific day
and time.
The switch number keyword is supported only on stacking
switches.
When specifying the tests to be scheduled, use these options:
• name—Name of the test that appears in the show
diagnostic content command output.
• test-id—ID number of the test that appears in the show
diagnostic content command output.
Configuring Online Diagnostics
- Quick Links:
- Table of Contents
- Setting the System Clock
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
