Configuring The Call Home Service For Direct Cloud Access - Cisco Catalyst 9200 Configuration Manual
Hide thumbs
Also See for Catalyst 9200:
- Hardware installation manual (128 pages) ,
- Installing manual (8 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Configuring the Call Home Service for Direct Cloud Access
Command or Action
Step 10
switchport access vlan vlan_id
Example:
Device(config)# interface GigabitEthernet1/0/1
Device(config-if)# switchport access vlan 100
Device(config-if)# switchport mode access
Device(config-if)# exit
Device(config)#
Step 11
ip route ip-address ip-mask subnet mask
Example:
Device(config)# ip route 192.0.2.0 255.255.255.255
192.0.2.1
Step 12
license smart transport callhome
Example:
Device(config)# license smart transport callhome
Step 13
ip http client source-interface interface-type
interface-number
Example:
Device(config)# ip http client source-interface
Vlan100
Step 14
exit
Example:
Device(config)# exit
Step 15
copy running-config startup-config
Example:
Device# copy running-config startup-config
Configuring the Call Home Service for Direct Cloud Access
Note
By default, the CiscoTAC-1 profile is already set up on the device. Use the show call-home profile all
command to check the profile status.
The Call Home service provides email-based and web-based notification of critical system events to CSSM.
To configure and enable the Call Home service, perform this procedure:
SUMMARY STEPS
1.
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
90
enable
Purpose
(Optional) Enables the VLAN for which this access port
carries traffic and sets the interface as a nontrunking
nontagged single-VLAN Ethernet interface.
Note
This step is to be configured only if the
switchport access mode is required.
Configures a route on the device.
Note
You can configure either a static route or a
dynamic route.
Enables the transport mode as Call Home.
Note
The license smart transport callhome
command is mandatory.
Configures a source interface for the HTTP client.
Note
The ip http client source-interface
interface-type interface-number command is
mandatory.
(Optional) Exits global configuration mode and returns to
privileged EXEC mode.
(Optional) Saves your entries in the configuration file.
Configuring Smart Licensing
- Quick Links:
- Table of Contents
- Setting the System Clock
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
