Filling The Engine With Oil; Assembling The Grass Bag - Toro 20960 Manual
55cm recycler lawn mower
Hide thumbs
Also See for 20960:
- Manual (96 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Available languages
Available languages
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine oil capacity: 0.47 L (16 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1.
Move the machine to a level surface.
2.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Dipstick
2. Add
3.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4.
Wipe the dipstick clean with a clean cloth.
Note:
Wait 3 to 5 minutes for the oil to settle
before checking it.
5.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
6.
Read the oil level on the dipstick
(Figure
Figure 5
3. Full
(Figure
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and
repeat steps
at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick; refer to
Changing the Engine Oil (page
Important:
is too low or too high and you run the
engine, you may damage the engine.
7.
Install the dipstick securely.
4
Assembling the Grass Bag
5).
No Parts Required
Procedure
g033497
5).
7
3
through
5
until the oil level is
19).
If the oil level in the engine
Figure 6
g230447
Advertisement
Chapters
Table of Contents
