Table of Contents
Advertisement
EZ-Manager Wizard (Cont.)
Automated Pro:Centric Configuration
Note: If the server is not yet configured on the system or if Pro:Centric data delivery will be over
IP and there is no Domain Name System (DNS) server, use the manual configuration option to
configure the TV's Pro:Centric server settings (see "Manual Pro:Centric Configuration" subsection
on page 17). See also note below regarding DNS requirements.
Note: If there is a DNS server at the site, you can create a "procentric.local" DNS entry with the
Pro:Centric server's IP address. Also, the Pro:Centric server's port number must be set to "80" to
allow the automated Pro:Centric IP configuration via the EZ-Manager to find the server.
Once the Pro:Centric data channel is found (a Pro:Centric Server Was Found screen will be
displayed) and the Pro:Centric Application Mode is determined, the wizard will advance to the
Processing the Pro:Centric Configuration screen, which shows the progress of the data downloads
(see example below). Note that some steps may require a few minutes.
If the process is successful, no further user interaction is required, though, in some instances,
where the option (for example "Next") is available, you may manually move forward to subsequent
steps within the wizard to speed up the process.
EZ-Manager Wizard
3
2
4
1
Processing the Pro:Centric Configuration...
Downloading the maintenance files takes several minutes.
Retrieving files from data channel 75
Application files
Maintenance files
– Updating Configuration File
Warning - Do not remove AC power or the signal cables during these steps
Note: If, after completing the search, the TV is unable to find the Pro:Centric data channel (while the
Searching for Pro:Centric Server screen is on display), the wizard will stop and show a Diagnostics
screen that enables you to manually return to the previous screen (to reinitiate the configuration) or
exit the wizard.
When the Pro:Centric Configuration is complete, an EZ-Manager Configuration Complete screen is
displayed, and after 10 seconds, the wizard exits, and the TV turns OFF.
EZ-Manager Wizard
4
1
2
3
EZ-Manager Configuration Complete
The TV will turn off in 3 second(s).
Installed Components
Pro:Centric Application
Maintenance Files
Reboot
Note: With the EZ-Manager Configuration Complete screen on display, you can also manually turn
off or reboot the TV. If desired, select Turn Off or Reboot, respectively, and then press OK on the
Installer Remote.
16
Please wait...
20%
GEM app downloaded
In progress...
GEM application downloaded
LT570H_Config.tlx
Turn Off
206-4340
Advertisement
Table of Contents
Troubleshooting
