Interface Port-Channel - Cisco Catalyst 3650 Command Reference Manual
Layer 2/3 command reference, cisco ios xe release 3.6e
Hide thumbs
Also See for Catalyst 3650:
- Hardware installation manual (118 pages) ,
- Manual (120 pages) ,
- Configuration manual (384 pages)
Table of Contents
Advertisement
Layer 2/3 Commands
interface port-channel
To access or create a port channel, use the interface port-channel command in global configuration mode.
Use the no form of this command to remove the port channel.
interface port-channel port-channel-number
no interface port-channel
Syntax Description
port-channel-number
Command Default
No port channel logical interfaces are defined.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
For Layer 2 EtherChannels, you do not have to create a port-channel interface before assigning physical ports
to a channel group. Instead, you can use the channel-group interface configuration command, which
automatically creates the port-channel interface when the channel group obtains its first physical port. If you
create the port-channel interface first, the channel-group-number can be the same as the port-channel-number,
or you can use a new number. If you use a new number, the channel-group command dynamically creates a
new port channel.
You create Layer 3 port channels by using the interface port-channel command followed by the no switchport
interface configuration command. You should manually configure the port-channel logical interface before
putting the interface into the channel group.
Only one port channel in a channel group is allowed.
When using a port-channel interface as a routed port, do not assign Layer 3 addresses on the physical
Caution
ports that are assigned to the channel group.
Do not assign bridge groups on the physical ports in a channel group used as a Layer 3 port channel
Caution
interface because it creates loops. You must also disable spanning tree.
Follow these guidelines when you use the interface port-channel command:
OL-32639-01
Channel group number. The range is 1 to 128.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
interface port-channel
Modification
This command was introduced.
39
Advertisement
Table of Contents
