Debug Platform Udld - Cisco Catalyst 3650 Command Reference Manual
Layer 2/3 command reference, cisco ios xe release 3.6e
Hide thumbs
Also See for Catalyst 3650:
- Hardware installation manual (118 pages) ,
- Manual (120 pages) ,
- Configuration manual (384 pages)
Table of Contents
Advertisement
debug platform udld
debug platform udld
To enable debugging of the platform-dependent UniDirectional Link Detection (UDLD) software, use the
debug platform udld command in privileged EXEC mode. To disable debugging, use the no form of this
command.
debug platform udld [error| event] [switch switch-number]
no debug platform udld [error| event] [switch switch-number]
Syntax Description
error
event
switch switch-number
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
The undebug platform udld command is the same as the no debug platform udld command.
When you enable debugging on a switch stack, it is enabled only on the active switch. To enable debugging
on a stack member, you can start a session from the active switch by using the session switch-number EXEC
command. Then enter the debug command at the command-line prompt of the stack member.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
36
(Optional) Displays error condition debug messages.
(Optional) Displays UDLD-related platform event debug messages.
(Optional) Displays UDLD debug messages for the specified stack member.
Layer 2/3 Commands
Modification
This command was introduced.
OL-32639-01
Advertisement
Table of Contents
