Memory Card Specifications Honeywell recommends the use of Single Level Cell (SLC) industrial grade microSD™ memory cards with the computer for maximum performance and durability. Contact a Honeywell sales representative for additional information on qualified memory card options.
Computer Features Speaker Touch Panel Good Read LED Volume Buttons Notification Battery Status Scan Button Power Button Microphone...
Page 4
Note: Hand strap not shown. Imager (LED/Laser Aperture) Camera Speaker Port Laser Safety Label Location Application Button Stylus microSD Card Side Scan Socket Cover Button Battery Battery Latch...
Page 5
Detach Hand Strap Detach the hand strap to access to the back of the computer. Note: Battery pack shown installed. To learn more, see “Install the Battery”.
Install a microSD Card Note: Format the microSD card before initial use. Note: Always power off the computer and remove the battery before attempting to install or remove a card.
Install the Battery The CK75 mobile computer ships with a Lithium-ion 3.7 V, 5200 mAH (19.24 Wh) battery manufactured for Honeywell International Inc. We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in damage not covered by the warranty.
Page 8
6 hours. Using the computer while charging the battery increases the time required to reach a full charge. If the CK75 is drawing more current than supplied by the charging source, charging will not take place. For additional information, see the user guide.
Turn Power On/Off The computer automatically turns on when you install the battery pack. Note: You should always place the computer in Battery Swap mode for a quick battery change. If you are removing the battery for a longer period, always power off the computer. To turn the computer off: Press and hold the Power button until the options menu appears.
About the Home Screen Notification / Status Bar Search Bar Touch initiate a voice Home Screen search or Panel command. Favorites Tray Navigation Buttons Touch the All Apps icon to access apps and settings. To learn how to customize the Home screen, see the user guide. Navigation and Function Buttons Buttons Description...
Page 11
Buttons Description Function Scan Trigger the scanner. Up, Down, Move up, down, right or left Left and on the screen. Right Modifiers Press a modifier key before pressing another key to access an alternate key value or function. Alternate key values appear on the keypad overlay near the relevant key.
Page 12
Scan a Bar Code Note: For optimum performance, avoid reflections by scanning the bar code at a slight angle. Point the computer at the bar code. Touch and hold the Scan button. Center the aiming beam over the bar code. When the scanner successfully reads the bar code, the computer beeps, and the Good Read LED turns on briefly.
Connect the CK75 to your computer using a USB charge/ communication accessory. By default, the CK75 is in USB charging only mode. To enable file transfers, swipe down from the top of the Home screen to access the Notifications panel.
To restart the computer if the touch panel display is unresponsive: • Press and hold the Power button for approximately 8 seconds until the computer restarts. Note: If you try to restart the computer and still experience issues, you may need to see the user guide for information on how to perform a Factory Reset (Clean Boot).
Microsoft Corpo- ration in the United States and/or other countries. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.