2.4GHz Expandable Cordless Phone System KX-TG2382B Model No. Pulse-or-tone-dialing capability Operating Instructions Contents: Location of Controls Connections Battery Installation/Battery Charge Recording a Greeting Message Making/Answering calls with the Handset Caller ID Service Automatic Answering Operation Listening to Messages Important Safety Instructions FCC and Other Information PLEASE READ BEFORE USE AND SAVE.
Please read IMPORTANT SAFETY INSTRUCTIONS on page 10 before use. Read and understand all instructions. Location of Controls I Base unit Button (ERASE) Button (GREETINGÒCHECK) Button (STOP) Button (GREETINGÒREC) Antenna Hook Display Button (SKIP) Button (REPEAT) CHARGE Indicator IN USE/HOLD Indicator Charge Contacts (ANSWER!ON)
Page 3
I Handset Back side Antenna Speaker Display Button (OFF) (TALK) Button Headset Jack Navigator Key (Speakerphone) Button (HOLD/INTERCOM/CLEAR) Button Button (TONE) Button (MUTE/FUNCTION) (PAUSE/REDIAL) Button Button (FLASH/CALL/WAIT) Microphone Charge Contacts I Charger Unit Charge Contacts CHARGE Indicator –3–...
(AC 120 V, 60 Hz) AC Adaptor Raise the antenna. • USE ONLY WITH Panasonic AC ADAPTOR PQLV10. • The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) I Charger Unit...
Battery Installation/Battery Charge I Battery installation 1 Install the battery in the handset. 2 Close the handset cover. I Battery charge To power the handset, charge the battery. Place the handset on the base unit or the charger for about 15 hours before initial use.
Recording a Greeting Message You can record a personal greeting message of up to 2 minutes. If a greeting message is not recorded, one of two pre-recorded greetings will be played when a call is received. • All messages (greeting, incoming, etc.) are stored in digital memory. The total recording time is about 15 minutes.
Making/Answering Calls with the Handset I To make a call 1 Press 2 Dial a telephone number. 3 To hang up, press or place the handset on the base unit or the (OFF) charger. • If "No link to base." is displayed and an alarm tone sounds in step 1, move closer to the base unit or place the handset on the base unit, and try again.
Caller ID Service This unit is compatible with a Caller ID service offered by your telephone company. After subscribing to a Caller ID service, the calling party’s information will be shown on the handset display after the first ring. The unit can record information of up to 30 different callers in the caller list. The Caller List information is sorted from the most recent to the oldest call.
Automatic Answering Operation I Setting the unit to answer calls Press to turn on the answering system. (ANSWER!ON) • The indicator lights and “Answer set” is heard. Listening to Messages You can see the total number of recorded messages on the base unit display. To listen to the messages, press (MESSAGE!PLAYBACK) •...
Important Safety Instructions When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 11. Read and understand all instructions. 12. Follow all warnings and instructions marked on this unit. 13.
Page 11
CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions. 1. Use only the battery(ies) specified. 2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions. 3.
FCC and Other Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:ACJ-----. If requested, this number must be provided to the telephone company.
Page 13
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS: 1) Remain on the line and briefly explain to the dispatcher the reason for the call. 2) Perform such activities in the off-peak hours, such as early morning or late evenings.
Page 14
CAUTION: To comply with FCC RF exposure requirements, the base unit should be installed with its antenna located at 20 cm or more from persons and handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-clips or similar body-worn accessories may not comply, therefore, should be avoided.
Page 15
•Attach a letter, detailing the symptom, to the outside of the carton. Symptom •Send the unit to an authorized servicenter, prepaid and adequately insured. •Do not send your unit to the Panasonic Consumer Electronics Company listed below or to executive or regional sales offices. These locations do not repair consumer products.