Appliqué, Monogramming And Embroidering; Appliqués; Monogramming And Embroidering - Brother LS-2000 Operation Manual
Hide thumbs
Also See for LS-2000:
- User manual (96 pages) ,
- Quick reference manual (2 pages) ,
- Operation manual (96 pages)
Table of Contents
Advertisement
Available languages
Available languages
APPLIQUÉ, MONOGRAMMING AND EMBROIDERING
Zigzag stitches can be used for sewing appliqués, monogramming and embroidering.
Appliqués
You can create an appliqué by cutting a different
piece of fabric into a shape and using it as a
decoration.
Stitch width
1-3
Stitch length
F-2
Needle position M
Presser foot
Zigzag
Needle
Single
Baste the cut design to the fabric.
a
Carefully sew around the edge of the design.
b
Memo
● Make reinforcing straight stitches at the
beginning and the end of stitching.
CAUTION
● Be careful that the needle does not hit a pin
during sewing, as the needle can break. You
may also be injured.
Cut away any fabric that is left outside the
c
stitching.
Remove the basting, if necessary.
d
Monogramming and
embroidering
Stitch width
0-5
Stitch length
Set at any position.
Needle position M
Presser foot
None
Needle
Single
Other
Darning plate
Place the darning plate on the needle plate as
a
shown below, and then remove both the
presser foot and presser foot holder assembly.
Draw the lettering (for monogramming) or
b
design (for embroidering) on the surface of
the fabric.
Put the fabric in the embroidery hoop with
c
the surface of the fabric facing up inside the
well.
Place the project under the needle and lower
d
the presser bar.
Draw up the lower thread through the project
e
at the starting position by turning the
handwheel toward you (counterclockwise),
and then sew a few stitches to reinforce the
stitching.
3
34
Advertisement
Chapters
Table of Contents
