Cisco NCS1004 Manual page 5
Configuring controllers
Hide thumbs
Also See for NCS1004:
- Command reference manual (110 pages) ,
- Hardware installation manual (70 pages) ,
- Manual (26 pages)
Advertisement
Configuring Controllers
Thu Feb 21 19:45:41.088 UTC
Controller State: Up
Transport Admin State: Automatic In Service
Laser State: On
LED State: Green
Optics Status
Transceiver Vendor Details
Optics Type:
Grey optics
Alarm Status:
-------------
Detected Alarms: None
LOS/LOL/Fault Status:
Alarm Statistics:
-------------
HIGH-RX-PWR = 0
HIGH-TX-PWR = 0
HIGH-LBC = 0
OOR-CD = 0
WVL-OOL = 0
IMPROPER-REM = 0
TX-POWER-PROV-MISMATCH = 0
Performance Monitoring: Enable
THRESHOLD VALUES
----------------
Parameter
------------------------
Rx Power Threshold(dBm)
Tx Power Threshold(dBm)
LBC Threshold(mA)
LBC High Threshold = 98 %
Polarization parameters not supported by optics
Total TX Power = 6.39 dBm
Total RX Power = 5.85 dBm
Lane
Laser Bias
TX Power
----
----------
----------
1
75.0 %
0.59 dBm
2
68.6 %
0.06 dBm
3
69.0 %
0.26 dBm
4
69.1 %
0.56 dBm
Form Factor
Name
Part Number
Rev Number
Serial Number
LOW-RX-PWR = 0
LOW-TX-PWR = 0
HIGH-DGD = 0
OSNR = 0
MEA
= 0
High Alarm
Low Alarm
----------
---------
4.9
-12.0
3.5
-10.1
N/A
N/A
RX Power
Output Frequency
----------
----------------
0.63 dBm
230.43 THz
-0.68 dBm
230.43 THz
-0.63 dBm
230.43 THz
-0.10 dBm
230.43 THz
: QSFP28
: CISCO-FINISAR
: FTLC1152RGPL-C2
: CISCO-FINISAR
: FNS22150LEC
Displaying the AINS Configuration
High Warning
Low Warning
------------
-----------
0.0
0.0
0.0
0.0
0.00
0.00
Configuring Controllers
5
Advertisement
