Table of Contents
Advertisement
Chapter 2
Installation Procedures
Step 2
Step 3
Note
Next Step
Warnings and Cautions
Warning
78-11190-01
When you have powered up the Cisco 600 series CPE, check that the Power LED
is ON.
If the Power LED is not lit, immediately remove the barrel power connector from
the Cisco 600 series CPE. Refer to
information.
To power down the Cisco 600 series CPE, unplug the power supply
cable from the Cisco 600 series CPE rear panel PWR connector.
Now that you have installed and powered on your Cisco 600 series CPE, you must
configure it.
To configure the Cisco 627, see
Cisco 627."
To configure the Cisco 633, see
Cisco 633."
To configure the Cisco 673, Cisco 675, Cisco 67e, Cisco 676, Cisco 677 or
Cisco 678, see
Chapter 5, "Configuration Procedures for the Cisco 67x CPE
Devices."
To prevent dangerous overloading of the power circuit, read the
label on the bottom of the Cisco 600 series CPE that indicates
maximum power load ratings. Failure to follow these rating
guidelines could result in a dangerous situation.
Chapter 6, "Troubleshooting,"
Chapter 3, "Configuration Procedures for the
Chapter 4, "Configuration Procedures for the
Cisco 600 Series Installation and Operation Guide
Next Step
for
2-19
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
