Advertisement
plates. (fig.1.3)
4.6.
Position the test piece, adjust the top plate by use of clamps (fig.1.1) lightly tighten, use a spanner to adjust cam (fig1.2), so that base
and top plate are aligned.
4.7.
ensure that there is even pressure on both ends.
4.8.
Raise the top folding plate (fig.1.3) buy lifting handles to create the fold. From this test, you will be able to determine how and where
the fold appears.
4.9.
When satisfied with the test results, proceed with the actual workpiece.
4.10.
By rotating the end clamps through the vertical axis, longer lengths of metel sheet can be folded , ie fold a section, unclamp, move
sheet, reclamp, fold second section etc.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
sole UK Distributor, Sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7AR
Original Language Version
01284 757500
01284 703534
tS01 | Issue 1 13/06/16
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
