Pioneer 9601 Instruction Manual

Mp5&fm receiver 7.0 inch tft lcd & manual telescopic

Download this manual

INSTALLATION

* Please read the following notice before installation *

1. Make sure that you or the professional are using our original connector in your first

installation, otherwise it could cause a short circus in the radio because the order of the

cable does not match correctly. If you use another connector, the radio may not turn on

or make any sound, even when you use our original connector for the second attempt.

Any damage caused by misuse of the wiring will not be included in the term of the

warranty.

2. After installing the radio, you may see some regular problems that most buyers can see,

but most of which can be verified and resolved by "F&Q"

Remove the stereo carefully from the box. keeping the box. For warranty and service of

the unit.

1. Remove the screws.

2. Unpack the car's dashboard and mounting bracket.

3. Check the size of the board window to meet the requirements. The holes of the lefit

alignment screws and the right plates.

4. By machine support fixed with screws in the dashboard.

5. Control panel installed.

PRECAUTIONS

Choose the mounting location carefully so that the unit will not interfere with the normal

driving functions of the driver.

Avoid installing the unit where it would be subject to high temperatures, from direct

sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive

vibration.

Use only the supplied mounting hardware for a safe and secure installation.

Adjust the mounting angle as desired.

Note

: Keep the release Key in the safe place as you may need it in future to remove the

unit from the car.

Page 1 INSTALLATION * Please read the following notice before installation * 1. Make sure that you or the professional are using our original connector in your first installation, otherwise it could cause a short circus in the radio because the order of the cable does not match correctly.
Page 3: Wiring Diagram
WIRING DIAGRAM WARNING Use the specified amperage fuse for each lead. Using a higher amperage fuse may cause serious damage. Reminder: You will receive an manual within 24 hours after order placement. Please check your mailbox or your Amazon message box. Troubleshooting: Before install the car stereo to your car (especially when you want to hire an expensive professional), please make a simple test.
Page 4 Camera Wiring: 1. Power cable: red and black Red -- reverse light positive Black -- reverse light negative 2. RCA cable: yellow port. insert into CAMIN port (yellow) on the radio 3. Make sure the pink cable on the radio power cable is connected to backing line. Thus, the device will show rear view image automatically when you are parking, and return to radio page when parking finishes.
Page 5: Specifications
(4) If the map is still empty, click on the map to show "+"and "-" button, click "+" to SPECIFICATIONS magnify the map until it shows streets FM TUNER Frequency Range 87.5-108MHz 4. Why the car radio shows "No Signal" when I’m reversing? Sensitivity 10 dBu If the camera can light up when it connect to power, the camera can work.
Page 6 Main Functions...

9601g