Maintenance; Transporting And Storing Outboard Motor; Dismounting The Outboard Motor - Yamaha F8 Operator's Manual
Hide thumbs
Also See for F8:
- Owner's manual (82 pages) ,
- Maintenance manual (130 pages) ,
- Owner's manual (90 pages)
Table of Contents
Advertisement
Available languages
Available languages
Maintenance
EMU43253
Transporting and storing out-
board motor
EWM02621
WARNING
USE CARE when transporting fuel tank,
whether in a boat or car.
DO NOT fill fuel container to maximum
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. When
transporting and storing the outboard
motor, disconnect the fuel line from the
outboard motor to prevent fuel from
leaking.
Never get under the outboard motor
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
Disconnect the fuel hose from the fuel joint
on the outboard motor.
Tighten the fuel tank cap and its air vent
screw.
Store the fuel tank in a well-ventilated
place.
Store the fuel tank in a place that is stable
and not exposed to shocks.
52
When the outboard motor is tilted for a pro-
longed time for mooring or trailering the boat,
make sure to follow the procedure listed be-
low.
Disconnect the fuel hose from the fuel joint
on the outboard motor.
Tighten the fuel tank cap and its air vent
screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the
tilt position using a motor support device
such as a transom saver bar. Consult your
Yamaha dealer for further details.
EMU43452
Dismounting the outboard motor
ECM01681
NOTICE
Do not hold the top cowling when mount-
ing or dismounting the outboard motor.
The top cowling could come off, causing
the outboard motor to fall.
1.
Stop the engine and land the boat.
2.
Disconnect the fuel hose from the fuel
joint on the outboard motor.
3.
For electric start models, disconnect the
battery cables from the battery terminals.
4.
To prevent steering movement, turn the
adjuster lever to "A" (if equipped with the
adjuster lever). To hold the steering
bracket easily, raise the tiller handle to
the vertical position (if equipped with the
tiller handle).
Advertisement
Chapters
Table of Contents
