A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the GD910 or compatibility with the net work, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
Page 5
The pictures in this manual are for illustrative purposes only; your actual hardware may look slightly different. G. Interference and Attenuation GD910 may interfere with sensitive laboratory equipment, medical equipment, etc. Interference from unsuppressed engines or electric motors may cause problems. H. Electrostatic Sensitive Devices...
Page 22
GD910 service manual GD910 service manual 3.2.5 GPIO map Over a hundred allowable resources, GD910 is using as follows except dedicated to SIM and Memory. GD910 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table [Table 3.2.5-1] S-Gold®3H GPIO pin Map...
Page 33
3. BB Circuit Technical brief GD910 service manual 3.3.2 Charging control - GD910 uses external charging IC which is ISL9221 Charging method : CC-CV Charger output voltage : 5.1 V Charging time : 2h 30m Charging current : 379 mA CV voltage : 4.2 V...
3. BB Circuit Technical brief GD910 service manual 3.5 SIM Interface GD910 supports 1.8V & 2.9V plug in SIM. SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with S- Gold3H and the SIM power supply enabled by PMIC. SIM Interface...
GD910 service manual 3.6 Memory 2Gbit NAND Flash & 1Gbit DDR SDRAM employed on GD910 with 16 bit parallel data bus thru ADD(0) ~ ADD(24). The 1Gbit Nand Flash memory with DDR SDRAM stacked device family offers multiple high- performance solutions.
3. BB Circuit Technical brief GD910 service manual 3.10 Audio 3.10.1 Audio amplifier GD910 use an external audio amplifier for speaker. TPA2005D1 is 1.1W speaker amplifiers with supporting differential input and direct drive . AUDIO AMP VBAT U202 C251 TPA2005D1ZQYR...
4. RF Circuit Technical Brief GD910 service manual [Figure 4.2.5-3] GD910 Front End Control Logic Table 4.3 WCDMA Part The single-chip transceiver is designed to fulfill the W-CDMA UTRA FDD system requirements for bands I, II, III, IV, V, VI and IX. It contains all active circuits required to simultaneously modulate an analog W-CDMA I/Q signal to the TX RF frequency and demodulate a RX RF W-CDMA signal to an I/Q baseband signal.