Page 1
PAW-BTANK200-300L 200-300 l. Languages in manual: EN - English HU - Hungary BK - Bulgarian - Italian CZ - Czech LV - Latvian NL - Dutch DA - Danish NO - Norwegian DE - German PL - Polish EE - Estonian ES - Spanish PT - Portugese - Finnish...
1. SAFETY INSTRUCTIONS 1.1 General information • Read the following safety instructions carefully before installing, maintaining or adjusting the buffer tank. • Personal injury or material damage may result if the product is not installed or used in the intended manner. •...
1.2 Safety instructions for users WARNINGS The appliance may be used by children older than 8 years old, elderly persons and persons with physical, sensory or mental disabilities or lacking experience and knowledge, if they are under supervision or taught about safe use of the appliance and if they are aware of the potential dangers.
157515 Cooling kit 3.3 Product dimensions All dimensions in mm. Product ø PAW-BTANK200L 1340 1275 941 PAW-BTANK300L 1820 1755 1421 301 Tolerance +/- 5 mm *Total height tolerance +0 / -13 mm 3.3.1 Delivery The product shall be transported carefully as shown, with packaging.
3.4 Requirements for installation location and positioning CAUTION The product shall be placed in a room with a drain to prevent any damages in case of water escaping from the product.. The product shall be placed in a dry and permanently frost-free position. The product shall be placed on a floor suitable for the total weight of the product when in operation.
3.4.2 Cooling kit installation A cooling kit is supplied with the product. When the product is used in a cooling system the cool- ing kit must be fitted to avoid condensation: Peel back protective film from the adhesive sur- face and place insulation pads in the indentations in the product base as shown in illustration.
4. INITIAL COMMISSIONING 4.1 Filling with water First check that all pipes are connected correctly. Then do the following: A) Vent the system, preferably at its highest point. B) Open water supply to the product. When water flows out of the vent the system is full. C) Fit the Automatic air vent valve (1) to the top connection, max.
5. WARRANTY CONDITIONS WARRANTY 1. Scope following: The Distributor warrants for 2 years from the • Chloride < 250 mg / L date of purchase, that the Product will: i) con- • Total Dissolved Solids (TDS) < 500 mg / L form to specification, ii) be free from defects in •...
6. DISPOSING OF THE PRODUCT Information for users on collection and dis- posal of old equipment: 6.1 Disposal The shown symbols on the products, packag- ing and/or accompanying documents mean that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please bring them to applicable col- lection points in accordance with your national...