Advertisement
Quick Links
Tool Rental Center
PURPOSE
SAFETY
Tool Inspection Process
Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete
procedures, refer to the Operator's Manual):
Maintenance Service Interval
After each use
After the first 25 hours
Every 25 hours
Revision 1 02-24-2021
Tool Turn Guide
Model No.
Follow the directions below to maintain this tool.
Refer to the product Operator's Manual for complete safety information.
Maintenance Procedure
• Check for missing or damaged parts, especially safety devices, shields, guards, and decals; ensure that the
machine starts and operates properly.
• Tighten all fasteners.
• Check the engine oil level.
• Grease the machine.
• Check the air filter cyclone housing for a layer of dirt in the bottom of the container. Clean it if dirty.
• Check the drive belt tension.
• Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth.
• Remove debris from the machine.
Change the engine oil.
Check the drive belt tension.
SGR-6 Stump Grinder
22600HD—316000001 and Up
Supplier Technical Support #:
888-384-9939 (US and Canada)
Supplier Website:
www.Toro.com
Toro Form No 3445-719 Rev A
Advertisement
Related Manuals for Toro SGR-6
Summary of Contents for Toro SGR-6
- Page 1 • Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth. • Remove debris from the machine. After the first 25 hours Change the engine oil. Every 25 hours Check the drive belt tension. Revision 1 02-24-2021 Toro Form No 3445-719 Rev A...
- Page 2 Check before cleaning that the fuel tank cap is properly in place to avoid getting water in the tank. Use care when using a high-pressure washer because it can damage decals, grease seals, and the engine. Important: Lubricate the cutting wheel blade bearings after cleaning. Revision 1 02-24-2021 Toro Form No 3445-719 Rev A...
- Page 3 To replace a tooth, remove the nut securing the tooth, then install a new tooth, washer, and nut in the same position (Figure 2). Torque the nut securing the tooth to 60 to 76 N∙m (44 to 56 ft-lb). Figure 2 Figure 1 Sharp tooth Worn tooth Tooth Tooth holder Flat land Washer Revision 1 02-24-2021 Toro Form No 3445-719 Rev A...
- Page 4 Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth. Check condition of the chip control flaps. Check the drive belt tension 137-7683 V-belt Revision 1 02-24-2021 Toro Form No 3445-719 Rev A...
-
Page 5: Recommended Routine Maintenance
Recommended Routine Maintenance: Recommended Parts Action Part Number Description Change the engine oil. Replace the air filter. Source from Honda Air filter Replace the spark plug. Source from Honda Spark plug Revision 1 02-24-2021 Toro Form No 3445-719 Rev A...